exclude an individual with a disability for a particular job or profession because of a health or safety risk, the employer still must assess whether a particular individual would pose a "direct...
Search Results "Directional Signage"
-
2. State and Local Laws
-
Landings [4.8.4]
Landings must be at least as wide as the ramp they serve and cannot slope more than 2% in any direction. Where ramps change direction, the landing must be at least 60 by 60 inches....
- Seton Florida State Fine Signs - $100 Fine F.S. 316.14
- Brady Worldwide Fine Sign 112500
-
Identification: ADA Standard Section 802.4.2
Each designated aisle seat shall be identified by a sign or marker. Advisory 802.4.2 Identification. Seats with folding or retractable armrests are intended for use by individuals...
-
Dimensions and Capitalization: ADA Standard Section 703.3.1
Braille dots shall have a domed or rounded shape and shall comply with Table 703.3.1. The indication of an uppercase letter or letters shall only be used before the first word of...
-
Stroke Thickness: ADA Standard Section 703.2.6
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character.
-
SECTION 1013 EXIT SIGNS
[See subsections ...]
-
11B-703.2.6 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character.
-
11B-703.3.1 Dimensions and capitalization
Braille dots shall have a domed or rounded shape and shall comply with Table 11B-703.3.1. The indication of an uppercase letter or letters shall only be used before the first word of...
-
11B-216.5.2 Electric vehicle charging spaces
Signs identifying Electric Vehicle Charging Spaces shall comply with Section 11B-812.8.
-
SECTION 1013 EXIT SIGNS
[See subsections ...]
-
1013.4 Raised character and braille exit signs
1013.4 Raised character and braille exit signs. [HCD 1-AC] Tactile exit signs shall be required at the following locations: 1. Each grade-level exterior exit door that is required...
-
11B-216.5.2 Electric vehicle charging spaces
Signs identifying Electric Vehicle Charging Spaces shall comply with Section 11B-812.8.
-
11B-703.2.6 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character.
-
11B-703.3.1 Dimensions and capitalization
Braille dots shall have a domed or rounded shape and shall comply with Table 11B-703.3.1. The indication of an uppercase letter or letters shall only be used before the first word of...
-
Section 36.208 Direct Threat (Preamble, Section-by-Section Analysis)
Section 36.208 Direct Threat Section 36.208(a) implements section 302(b)(3) of the Act by providing that this part does not require a public accommodation to permit an individual to participate...
-
703.4.1 Height Above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60...
- Access Board: Tactile Sign Location
-
§ 37.5(h)
part for an entity to refuse to provide service to an individual with disabilities because that individual engages in violent, seriously disruptive, or illegal conduct, or represents a direct...
-
18. Hard-to-Maneuver Stops
location that is difficult, but not impossible or impracticable, to access should generally be granted as long as picking up the passenger does not expose the vehicle to hazards that pose a direct...
-
Areas of Refuge: ADA Standard Section 216.4.2
Section 216.4.2 covers scoping requirements in the current ADA Standards for signs at areas of refuge.
- Takeform Fusion Signage Miscellaneous Room Identification Type E.2