Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
Search Results "Side Transfer Surface"
Commonly Searched Documents
-
Tent Pads and Tent Platforms [1013]
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Detectable warning surfaces are not required on curb ramps and blended transitions that connect the access aisle to the sidewalk, including where the sidewalk is at the same level as the...
-
F. Check-In Areas
If a permanent reception counter is used for check in, make sure to provide a writing surface at an accessible height for people who use a wheelchair, scooter, or other mobility device....
-
4.6.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
2. Referenced Documents
Guide for Conducting Subjective Pavement Ride Quality Ratings E2133 Standard Test Method for Using a Rolling Inclinometer to Measure Longitudinal and Transverse Profiles of a Traveled Surface...
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
§ 38.159(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width....
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ◼ ...
- Stanley SB600 Bifolding Door
- Living Earth Crafts Cloud 9 Spa Treatment Table
- Spectrum Industries Inc. Freedom One eLift Lectern™ Adjustable Height Lecterns
- Bradley 20.6 Gallon Waste Receptacle 355
-
EXHIBIT F ADA Maintenance Checklist
There also must be sufficient maneuvering room in front of the door on either side. a. Is there an unobstructed clear flat area at the exterior side of the accessible door?...
-
4.1 Introduction
Policy makers have to make a decision about who should be accommodated by knee and toe clearances or identify alternative solutions like providing side access as well as front access or...
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
.) [§ 4.3.7] The ramp, or ramp run, must be at least 36 inches wide, not including the flared sides. [§ 4.7.3] The ramp run must have detectable warnings – i.e.,...
-
Feature 2 - Routes to the Building Entrance
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Wheelchair Spaces
Wheelchair spaces may be placed side-by-side, as reflected in specifications for width that are specific to adjoining spaces....
-
M303.2.3 Depth (Section-by-Section Analysis)
depth requirements based on how the wheelchair user enters the space: for spaces entered from the front or rear, 48 inches deep minimum; and for spaces that can only be entered from the side...
-
704.11 Parapets
walls, such framing and elements supporting such framing shall not be of less than 1-hour fire-resistance-rated construction for a width of 4 feet (1220 mm) measured from the interior side...
-
A. Format and Organization
A side-by-side comparison of the 2016 Non-Rail Vehicle Guidelines and the existing guidelines is available on the Access Board’s website (www.access-board.gov)....
-
B. Question 2: Section 904.4.1 and Clear Counter Space
Individuals using wheelchairs can approach sales and service counters from the side, and, assuming the necessary elements, features, or merchandise necessary to complete a business transaction...
-
Nonmotorized Kick Scooters
The platform is usually relatively short and too narrow (100 mm (4 inches)) for two feet side by side....
-
Function Keys
It included specifications for key surfaces to be raised 1/25 inch minimum and that outer edges have a radius of 1/50 inch maximum (707.4.2)....