Height of Tables or Counters [4.32.4] Counter and table surface heights (28 to 34 inches) should be specified in consideration of the intended use....
Search Results "Designed Use"
-
Height of Tables or Counters [4.32.4]
-
Compliance Problems Due to Lack of Accessibility Guidelines
The Fair Housing Act identifies the ANSI Standard as providing design standards that would achieve compliance with the Act's accessibility requirements....
-
4.3.2 Seat Height
Designing only for WhMD users would cause discomfort and safety problems for too many people....
-
C. Corporate ADA Contact Person, ADA Liaison, and ADA Grievance Procedure
Within sixty (60) days of the effective date of this Agreement, Atlantis will designate or hire a Corporate ADA Contact Person and identify that person to the United States. ...
- American Standard Madera 1.28 gpf ADA EverClean Toilet with Exposed Manual Flush Valve System
- American Standard Cadet 1.1 gpf FloWise Right Height Pressure Assisted Elongated Toilet 2467100
- American Standard Madera 1.6 gpf ADA EverClean Toilet with Exposed Manual Flush Valve System
- American Standard Yorkville 1.1 gpf FloWise Right Height Elongated Pressure Assisted Toilet
- American Standard Madera 1.28 gpf EverClean Toilet with Exposed Manual Flush Valve System
- Besam SW200i Surface Mounted Swing Door Operator
- Norton 6000 Series Low Energy Operator
-
Section 1193.31 Accessibility and usability (Section-by-Section Analysis)
Section 1193.31 Accessibility and usability (Section-by-Section Analysis) This section provides that, subject to section 1193.21, manufacturers must design, develop and fabricate their...
-
Section 36.406(f)(2)
This rule, which is designed to prevent a public accommodation from placing wheelchair spaces and companion seats on one side of the facility only, is consistent with the Department’s enforcement...
-
1132A.8 Hand-activated door hardware
locking doors that are hand-activated and on an accessible route shall be operable with a single effort by lever-type hardware, panic bars, push-pull activating bars or other hardware designed...
-
Lines of Sight at Dining Areas in Sports Venues
Designers called attention to dining areas integrated into the seating bowl of sports venues that are tiered in order to provide adequate lines of sight....
-
Transfer Height
Where possible, designers are encouraged to locate the transfer device seat within 17 to 19 inches above the load and unload surface....
-
1.2 MDE Advisory Committee Membership
Table 1.2 lists the 24 organizations selected; each organization could designate a primary representative and a secondary representative who would participate in the absence of (or at the...
-
R304.5.3 Cross Slope
Pedestrian street crossings without yield or stop control are crossings where there is no yield or stop sign, or where there is a traffic signal that is designed for the green phase....
-
"1991 Standards" and "2004 ADAAG" (Section-by-Section Analysis)
The term "1991 Standards" refers to the currently enforceable ADA Standards for Accessible Design, codified at 28 CFR part 36, App. A. ...
-
J. Valet Parking and New Parking Garage
construct accessible parking spaces, entrances, and routes of travel as required by 2010 Standards §§ 208.1, 208.2, 208.2.4, 208.3.1, and 502.1-503.5, and to erect appropriate signage designating...
-
"1991 Standards" and "2004 ADAAG" (Section-by-Section Analysis)
The term "1991 Standards" refers to the currently enforceable ADA Standards for Accessible Design, codified at 28 CFR part 36, App. A. ...
-
ADA Requirements - Wheelchairs, Mobility Aids, and Other Power-Driven Mobility Devices
These requirements, or rules, clarify and refine issues that have arisen over the past 20 years and contain new, and updated, requirements, including the 2010 Standards for Accessible Design...
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....