Where the full length of a trail does not fully comply with 1017, a passing space shall be located at the end of the trail segment that fully complies with 1017....
Search Results "Transitional Segment"
-
1017.4 Passing Spaces
-
11B-247.1.1 General
Detectable warnings are provided for the benefit of persons with visual impairments to indicate transitions to potentially hazardous areas. ◼...
-
11B-247.1.1 General
Detectable warnings are provided for the benefit of persons with visual impairments to indicate transitions to potentially hazardous areas. ◼...
-
§382.117(a)(2)
(2) On a flight segment scheduled to take 8 hours or more, you may, as a condition of permitting a service animal to travel in the cabin, require the passenger using the service animal to...
-
Georgia-Pacific ® Translucent Smoke Push Paddle Roll Paper Towel Dispenser
The contemporary design fits perfectly in a variety of market segments including manufacturing, schools, and high-traffic areas....
-
§382.157(b)
As a foreign carrier, you are covered by this section only with respect to disability-related complaints associated with any flight segment originating or terminating in the United States...
-
1016.8.2 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
1016.8.2 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
4.8.5* HANDRAILS
Handrails shall comply with 4.26 and shall have the following features: (1) Handrails shall be provided along both sides of ramp segments....
-
SafePath: Overview of Ramps and Reducers for ADA Compliance by SafePath Products
Over the past 17 years, SafePath™ has developed hundreds of transition products, becoming one of the largest suppliers of transition products in the industry today....
-
Turning Space: ADA Standard Section 809.2.2
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
Designed Use
There is only one “Designed Use” per trail or trail segment....
-
2.5.3 Width
Where resting intervals are provided within an outdoor recreation access route, resting intervals shall be at least as wide as the widest segment of the outdoor recreation access route leading...
-
Accessibility - Flatness and Lippage
Concrete Paving Products & Cbaracteristics Construction Placement & Surface Tolerances Joint or bond lines All segmental concrete paving products: Horizontal...
-
R304.5.1 Width
The width of curb ramps and blended transitions shall comply with 304.5.1.1 or 304.5.1.2, as applicable....
-
f-v
[ADA Standards § 4.8.4] Yes No Note: if the running slope is less than 1:16 but more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing]....
-
4d.
[ADA Stds 4.8.4] Yes _____ No _____ Note: When the running slope is less than 1:16 and more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing....
-
6d. Ramp Length
[ADA Stds 4.8.4] Note: When the running slope is less than 1:16 and more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing. Yes _____ No _____...
-
7.4.5 Passing Spaces
A passing space must also be provided at the end of any segment of trail that meets the requirements of 7.4, if the full length of the trail does not meet the requirements. ...
-
1017.10 Trailhead Signs
This section requires trail information signs at trailheads to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and...
-
11B-809.2.2 Turning space
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
11B-809.2.2 Turning space
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
