(b) The Assistant Attorney General--after consultation with the Architectural and Transportation Barriers Compliance Board and consideration of the materials and information submitted pursuant...
Search Results "Sustainable Material"
Filters
Commonly Searched Documents
-
§ 36.604(b)
-
Accessible Classroom Style
This set-up is very helpful when participants need a surface to take notes and refer to materials....
-
§ 38.83(c)(1) Design load
a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
-
Slip Resistance
Compliance with the standards requires specifying surface materials, textures, or finishes that prevent or minimize slipperiness under the conditions likely to be found on the surface....
-
Steelcase Series 3 Height-Adjustable Work Surface with Crank
Designing for Sustainability We believe the only way to provide the best office furniture solutions is to ensure they’re the best products for the environment....
-
What values are recommended for ground and floor surfaces along an accessible route?
In the Access Board research, the static coefficients of friction for a variety of common indoor and outdoor surfacing materials were measured in place using the NBS-Brungraber Tester with...
-
3.2 Study Limitations and Other Issues
from asphalt roofing material....
-
1008.2.6 Ground Surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
11B-1008.2.6 Ground surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
1132A.4, Item 4
Secondary exterior doors onto decks, patios or balcony surfaces constructed of impervious materials (e.g., concrete, brick, flagstone) may have a maximum change in height from the interior...
-
E202.3 Federal Contracts
ICT that is incidental to a contract includes materials which are, themselves, not deliverables under the contract....
-
7.2(2)(iii)
folding shelf attached to the main counter on which an individual with disabilities can write, and (2) use of the space on the side of the counter or at the concierge desk, for handing materials...
-
11B-1008.2.6 Ground surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
§ 38.125(c)(1) Design load
pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
-
§ 38.95(c)(1) Design load
pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
-
11B-705.1.1.3 Color and Contrast
The material used to provide visual contrast shall be an integral part of the surface....
-
11B-1008.2.6 Ground surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities. ◼...
-
Eliason Corporation SCP-8 High Pressure Laminate Traffic Door
door body is constructed of a 7-ply exterior grade plywood clad on both sides with a .032" thick decorative high pressure laminate and capped with 18 gauge stainless steel Face Sheet Material...
-
POWER DISRUPTION
Encourage individuals who use life-sustaining equipment to register with their utility provider. REMEMBER!...
-
Paragraph (f) (Advisory Guidance)
Reduce the force needed to operate controls or latches and avoid the need for sustained pressure or activity (e.g., use guards rather than increased strength requirements to avoid accidental...
-
4.26.3(2)
(2) Shear stress induced in a grab bar or seat by the application of 250 lbf (1112N) shall be less than the allowable shear stress for the material of the grab bar or seat....
-
RECOMMENDATIONS
measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order to enable land managers to determine whether the surface material...
-
1132A.4.1 Thresholds
., floor material changes at door thresholds) shall not exceed ½ inch (12.7 mm). Thresholds shall comply with the following:...
-
Contrast
The proposed rule required the material used to provide contrast be an integral part of the truncated dome surface (705.2.2)....
