The verbal annunciator shall be 10 dB minimum above ambient, but shall not exceed 80 dB, measured at the annunciator.
Search Results "Non-Positive Shut Off"
Commonly Searched Documents
-
11B-407.4.8.2.2 Signal level
-
11B-407.4.8.1.3 Floor arrival
As the car passes a floor and when a car stops at a floor served by the elevator, the corresponding character shall illuminate. Exception: Reserved. [2010 ADA Standards]...
-
11B-407.4.8.1 Visible indicators
Visible indicators shall comply with Section 11B-407.4.8.1.
-
T704 Announcement Systems
announcement systems must have signage viewable onboard from all wheelchair spaces and priority seats, APTA expressed concerns about the cost of providing signs for rear-facing wheelchair positions...
-
M302.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided....
-
407.4.8.2.1 Signal Type
[ECTCR UFAS 4.10.13] EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with...
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
Seats
In the raised (load) position, the centerline of the seat must be located over the deck, a minimum of 16 inches from the edge of the pool....
-
M302.2.2 Sunset Provision (Section-by-Section Analysis)
As discussed in Section IV.B.1.a. (Significant Changes – Transfer Surface Adjustability), this is a new provision added to the final rule in conjunction with the new requirement of a...
-
Designations and Indicators of Car Controls: ADA Standard Section 408.4.7
Section 408.4.7 covers the current ADA Standards for designations and indicators of car controls in limited-use/limited-application elevators.
-
11B-408.4.8 Emergency communications
Car emergency signaling devices complying with Section 11B-407.4.9 shall be provided.
-
11B-408.4.7 Designations and indicators of car controls
Designations and indicators of car controls shall comply with Section 11B-407.4.7.
-
Footrests and Armrests
Armrests are not required, however if provided, the armrest opposite the water must be removable or be able to fold clear of the seat when the seat is in the raised (load) position....
-
Submerged Depth
Submerged Depth Lifts must be designed so that the seat will submerge to a minimum of 18 inches below the stationary water level. This will ensure buoyancy for the person on the...
-
Lifting Capacity
Lifting Capacity Lifts must have the capability of supporting a minimum weight of 300 pounds and be capable of sustaining a static load that is at least 1.5 times the rated load....
-
T505 Fare Collection Devices
[See subsections ...]
-
T602 Wheelchair Spaces
[See subsections ...]
-
T304 Operable Parts
[See subsections ...]
-
T505.3 Location of Operable Parts
Operable parts shall be located so that they are reachable by passengers using wheelchair when parked in a clear space 30 inches (760 mm) wide minimum and 48 inches (1220 mm) long...
-
§8.21(c)(2)(ii) Historic preservation programs or activities
(ii) Historic preservation programs or activities. In meeting the requirements of §8.21(c) in historic preservation programs or activities, a recipient shall give priority to methods...
-
7. In § 37.103 (b) and (c), remove the words “or an over-the-road bus,”
§ 37.103 [Amended] 7. In § 37.103 (b) and (c), remove the words “or an over-the-road bus,”.
-
T602 Wheelchair Spaces
The technical requirements for wheelchair spaces include provisions on surfaces, approach, and size. Under the final rule, as with the existing guidelines, one full unobstructed side...
-
Are turn-key locks prohibited by the standards?
Key locks or key cards are not prohibited by the standards which apply only to the fixed portions of operable parts. Similarly, items dispensed by ATMs and fare machines, such as...
-
M302.1 General
Diagnostic equipment that supports patients in a seated position shall comply with M302. ...