Common use circulation paths located within employee work areas that are an integral component of work area equipment shall not be required to comply with Section 11B-402. 3....
Search Results "Equipment"
Commonly Searched Documents
- 
    
  
  11B-206.2.8 Employee work areas
  
- 
    
  
  Section 36.211 Maintenance of Accessible Features (Section-by-Section Analysis)
  Section-by-Section Analysis) Section 36.211 of the 1991 title III regulation provides that a public accommodation must maintain in operable working condition those features of facilities and equipment... 
- 
    
  
  M303.1 General
  Diagnostic equipment used by patients seated in a wheelchair shall comply with M303.... 
- 
    
  
  M303.1 General
  Diagnostic equipment used by patients seated in a wheelchair shall comply with M303.... 
- seca 664 - electronic wheelchair scale_without comments - seca1840
- CPF Challenge: 7 Minute Workout OFFICIAL TRAILER (2017)
- 
    
  
  Standing Supports (M304.3 and M305.3)
  Standing Supports (M304.3 and M305.3) M304.3 Proposed Provision: Would require standing supports to be provided on each side of the standing surface on diagnostic equipment used by patients... 
- 
    
  
  M301.2.1 Adjustability
  Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A. A low transfer position... 
- 
    
  
  M301.2.2 Sunset
  The low transfer position height, Item A of M301.2.1, shall cease to have effect on [Insert date 5 years after date of publication in the Federal Register]. 
- 
    
  
  M301.2.2 Sunset Provision (Section-by-Section Analysis)
  As discussed in Section IV.B.1.a. (Significant Changes – Transfer Surface Adjustability), this is a new provision that was added to the final rule in conjunction with the new... 
- 
    
  
  5.7 Lift Compatibility
  5.7 Lift Compatibility. 
- 
    
  
  5.7 Lift Compatibility Recommendations
  5.7 Lift Compatibility Recommendations 
- 
    
  
  B. M301 Diagnostic Equipment Used by Patients in a Supine, Prone, or Side-lying Position and M302 Diagnostic Equipment Used by Patients in a Seated Position
  In the final rule M301 and M302 provide the technical requirements for diagnostic equipment used in the supine, prone, or side-lying position, and diagnostic equipment used by patients in... 
- 
    
  
  M303.2.4.2.2 Height
  25 inches (635 mm) maximum at 9 inches (230 mm) above the floor and at a depth of 8 inches (205 mm) minimum at 27 inches (685 mm) above the floor measured from the leading edge of the equipment... 
- 
    
  
  M303.4 Components
  Where components of diagnostic equipment are used to examine specific body parts, the components shall be capable of examining the body parts of a patient seated in a wheelchair.... 
- 
    
  
  M303.4 Components
  Where components of diagnostic equipment are used to examine specific body parts, the components shall be capable of examining the body parts of a patient seated in a wheelchair.... 
- 
    
  
  M305.1 General
  Supports shall comply with M305. 
- 
    
  
  M305.1 General (Section-by-Section Analysis)
  This is an introductory section. 
- 
    
  
  M305.1 General
  Supports shall comply with M305, as applicable. 
- 
    
  
  M305.2.5 Surface Hazards
  Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges. 
- 
    
  
  M305.2 Transfer Supports
  Transfer supports shall comply with M305.2. 
- 
    
  
  M305.2.5 Surface Hazards (Section-by-Section Analysis)
  The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports. No public comments were submitted on this issue, but the MDE... 
- 
    
  
  5.4 Transfer Supports
  5.4 Transfer Supports. 
- 
    
  
  5.4 Transfer Supports Recommendations
  5.4 Transfer Supports Recommendations 
 
              