Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
Search Results "Vertical Access"
Commonly Searched Documents
-
504.5 Nosings
-
1008.3.2.3 Transfer Supports
Some examples of supports include a rope loop, a loop type handle, a slot in the edge of a flat horizontal or vertical member, poles or bars, or D rings on the corner posts....
-
7.4.5.1 Size
Vertical alignment at the intersection of the trails that form the T-shaped space shall be nominally level....
-
Spout Location [4.15.3]
The trajectory of water flow must be vertically "parallel" or "nearly parallel" to the face of the unit....
-
§ 38.73(d)(1) Requirements
Vertical alignment may be accomplished by vehicle air suspension, automatic ramps or lifts, or any combination....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
RESPONSE: A single multiport EV charger that can simultaneously charge two vehicles can be used to serve two EV spaces required to be accessible....
- Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
-
Preserving elevator access in building where it might not be required.
However, the building has an elevator, which currently provides access to all 6 floors and a mezzanine between the first and second floors. ...
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section B.2.ii, above...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
Unless the required number of accessible ground level play components are provided, the new play component would be required to be accessible....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
4.5.2 Changes in Level
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
4.5.2 CHANGES IN LEVEL
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
Handrails [§504.6, §505]
A vertical clearance 9” minimum between upper and lower handrails will help prevent entrapment....
-
§ 38.23(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk to ramp may be vertical...
- International Code Council (ICC): Become an ICC Certified Accessibility Inspector/Plans Examiner
- Figure 610.3 Extent of Seat – Drawing from the U.S. Access Board
- Figure 405.7 Ramp Landings – Drawing from the U.S. Access Board
- Figure 703.3.2 Position of Braille – Drawing from the U.S. Access Board
- Figure 406.7 Islands in Crossings – Drawing from the U.S. Access Board
- Figure 504.5 Stair Nosings – Drawing from the U.S. Access Board
-
Stanley Access Technologies Dura-Care 7000 Manual Door System
Requires the Premium User plan or above. (Login or upgrade your account!)