Recognized tolerances are not intended to apply to design work. It is good practice when specifying dimensions to avoid specifying a tolerance where dimensions are absolute....
Search Results "Employee Work Area"
-
11B-104.1.1 Construction and manufacturing tolerances
-
105 Referenced Standards
Mechanical Engineers (ASME) for various elevators and platform lifts (105.2.2) American Society for Testing and Materials (ASTM) for use zones, play equipment, and accessible surfaces at play areas...
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At boarding platforms for buses and rail vehicles, detectable warning surfaces must extend the full length of the public use areas of the platform....
-
"Other Power-Driven Mobility Device" (Section-by-Section Analysis)
., Segway®), or any mobility aid designed to operate in areas without defined pedestrian routes." ...
-
TEST NO. 2 – SITE ANALYSIS TEST
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope....
-
TEST NO. 2 – SITE ANALYSIS TEST
with multiple entrances, it is not required to provide an accessible route to all ground floor units under the following conditions: Calculate the percentage of the total buildable area...
-
Providing minimal protection. (Section-by-Section Analysis)
While many individuals with PTSD may benefit by using a service animal, the work or tasks performed appropriately by such an animal would not involve unprovoked aggression, but could include...
-
Doors: ADA Standard Section 604.8.1.2
Section 604.8.1.2 covers the current ADA Standards for wheelchair accessible compartment doors.
-
11B-810.6 Rail station signs
By scanning an area, the person will hear the sign. This means that signs can be placed well out of reach of Braille readers, even on parapet walls and on walls beyond barriers....
-
11B-810.6 Rail station signs
By scanning an area, the person will hear the sign. This means that signs can be placed well out of reach of Braille readers, even on parapet walls and on walls beyond barriers....
-
Car Dimensions and Doors: ADA Standard Section 408.4.1
Section 408.4.1 covers the current ADA Standards for the car dimensions and doors of limited-use/limited-application elevators.
-
Toilet Facilities and Bathing Facilities: ADA Standard Section 809.4
Toilet and bathing fixtures required to comply with 603 through 610 shall be located in the same toilet and bathing area, such that travel between fixtures does not require travel between...
-
11B-1009.2.1 Pool lift location
Where multiple pool lift locations are provided, no more than one pool lift shall be required to be located in an area where the water level is 48 inches (1219 mm) maximum....
-
11B-1009.2.1 Pool lift location
Where multiple pool lift locations are provided, no more than one pool lift shall be required to be located in an area where the water level is 48 inches (1219 mm) maximum....
-
Dispersion: ADA Standard Section 235.2.1
Section 235.2.1 covers scoping requirements in the current ADA Standards for dispersion of boat slips.
- American Standard Decorum 0.125 gpf Urinal System with Manual Flush Valve
- PEMKO 5" Latching Panic Saddle Threshold No. 2005-P
- Ultratec Miniprint 425 TTY
- PEMKO 5" Latching Panic Saddle Threshold No. 2005-V
- Be My Eyes Live Video Chat App
- Scitec 2500 Series Single Line Desk and Wall Telephones
- Tork Elevation® Xpress® Hand Towel Dispenser, White
- Mockett PCS48D Clamp-On Horizontal E/E Power Dock
- New Horizons Disability Empowerment Center - Prescott Valley, AZ