The CH-100 should be placed at building and department entrances of public places such as: municipalities, hospitals, shops, offices etc., offering disabled, senior citizens and people pushing...
Search Results "Fire-Building Surface"
Commonly Searched Documents
- Step Hear CH-100 Call Unit Service Button
- Cavity Sliders USA Inc. CL100 ADA Privacy Lever Lock for Pocket Doors
- Hager Companies Five Knuckle - Full Mortise Swing Clear Hinge BB1260
-
D. STRUCTURAL MODIFICATIONS
take the following actions: Within 12 months of the effective date of this Agreement, Lewisboro will complete the renovations of the Onatru Farmhouse so as to ensure that that building...
- Mohawk Group Chilled Check Carpet Tiles
- Guardian Recessed Safety Station with Drain Pan GBF2173
-
1009.5.2 Transfer Space
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
403.5.1 Clear Width
Except as provided in 403.5.2 and 403.5.3, the clear width of walking surfaces shall be 36 inches (915 mm) minimum....
-
1009.5.4 Transfer Steps
The surface of the bottom tread shall extend to a water depth of 18 inches (455 mm) minimum below the stationary water level. Advisory 1009.5.4 Transfer Steps....
-
R406.3 Unobstructed Side Reach
approach to an element and the side reach is unobstructed, the high side reach shall be 1220 mm (4.0 ft) maximum and the low side reach shall be 380 mm (1.25 ft) minimum above the finish surface...
-
Built-up Curb Ramps [4.7.6]
(The surface of access aisles cannot slope more than 2% in any direction)....
-
4.7.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Wheelchair Work Measurement Method
Wheelchair work per meter values for straight and turning were determined for all test course surfaces except sand, under dry conditions using the Wheelchair Work Measurement Method in accordance...
-
Fixed tactile maps
Placement on a horizontal or near horizontal surface provides the map reader with a real world orientation....
-
6.9 Tread Obstacles
Where the surface is paved or is elevated above the natural ground, obstacles shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
11B-704.5 TTY shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
Protruding Objects
Examples of indoor protruding objects include fire extinguishers and wall-mounted display cases, wall sconces, open staircases, exit signs, overhead signs, banners, and some arched doorways...
-
Reassignment
The hospital violates the ADA if it fires the employee rather than reassigning her to a vacant position for which she is qualified and in which she could perform the essential functions...
-
Issue 13: Stub poles
In addition, a fire hydrant is between the crosswalk location (and the curb ramp) and the APS. Figure 16: Stub pole was installed to locate APS near the crosswalk....
-
Emergency Contacts
numbers in your device such as your: Close family, personal assistants, neighbors (See “Out-of-town emergency contacts” http://www.jik.com/disaster-individ.html#Templates) and police, fire...
-
Typical Transfer Techniques: Staff Assistance and Patient Lifts
Other individuals will need simple tools such as a transfer board (a product made of a smooth rigid material which acts as a supporting bridge between a wheelchair and another surface, along...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Grade breaks are not permitted on the surface of ramp runs and turning spaces. Surface slopes that meet at grade breaks must be flush....
-
Transfer Supports (M301.3.1, M302.3.1, and M305.2)
M305.2.1 would require the transfer supports to be located within reach of the transfer surface and not obstruct transfer onto the surface when in position....
-
Clearance in Base (M301.4.1 and M302.4.1)
would require the clearance in the base to be 44 inches wide minimum, 6 inches high minimum measured from the floor, and 36 inches deep minimum measured from the edge of the examination surface...