Wheelchair spaces and companion seats shall be located on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria: (i) It is located within the...
Search Results "Water Closet Clear Floor Space"
-
221.9 Stadium Style Movie Theaters
- Willoughby Industries WWF-3606 Six Station Full Round 36" Stainless Steel Deep Bowl Washfountain
- Willoughby Industries WWF-4206 Six Station Full Round 42" Stainless Steel Deep Bowl Washfountain
-
11B-503.3 Access aisle
Passenger drop-off and loading zones shall provide access aisles complying with Section 11B-503 adjacent and parallel to the vehicle pull-up space....
-
Height: ADA Standard Section 902.4.2
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (760 mm) maximum above the finish floor or ground....
-
Tray Slides: ADA Standard Section 904.5.2
The tops of tray slides shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground....
-
11B-409.4.4 Leveling
Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions....
-
SECTION 1018 AISLES
[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
-
§ 38.75(c)
a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character height (using an upper case “X”) of 5/8 inch, with “wide” spacing...
- Delta How to Install a Pull-Out Faucet Featuring Touch20® Technology
- Bradley 3-Station Frequency Lavatory System FL-3H & FL-3L
-
Section 36.404 Alterations: Elevator Exemption (Section-By-Section Analysis and Response to Comments)
As is the case with new construction, the term "shopping center or shopping mall'' only includes floor levels housing at least one sales or rental establishment, or any floor level that...
-
11B-813.2.6 Shelf
No fewer than one shelf shall be provided in close proximity to the changing table at 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....
-
502.3.1 Width
Access aisles serving car and van parking spaces shall be 60 inches (1525 mm) wide minimum....
-
Tactile Signage
Tactile Signage Raised and Braille characters are required on signs that "designate permanent rooms and spaces."...
-
§ 38.179(b)
In addition, each such unit shall comply with §38.23 (b) or (c) and shall provide at least one space for wheelchair or mobility aid users complying with §38.23(d) of this part unless the...
-
9.1 GENERAL
In addition, employee toilet rooms, water fountains, lunchrooms, lounges, attendance-recording equipment, medical treatment rooms, emergency signals, and switches and controls shall be made...
-
503.3 Access Aisle
Passenger loading zones shall provide access aisles complying with 503 adjacent to the vehicle pull-up space....
-
11B-411.2.1.7.4 Adjacency assignment
Exception: The most adjacent elevator serving the selected floor shall be assigned by hall call consoles located outside the elevator landing....
-
46. Can an employer claim undue hardship solely because a reasonable accommodation would require it to make changes to property owned by someone else?
Example A: X Corp., a travel agency, leases space in a building owned by Z Co. One of X Corp.'s employees becomes disabled and needs to use a wheelchair....
-
4.34.5.4 BATHTUBS
If a bathtub is provided, then it shall have the following features:
-
1010.1.6 Thresholds
Thresholds at doorways shall not exceed ¾ inch (19.1 mm) in height above the finished floor or landing for sliding doors serving dwelling units or ½ inch (12.7 mm) above the finished floor...
-
1132A.1 Primary entry doors and required exit doors
The requirements of Sections 1126A.3 shall apply to maneuvering clearances at the side of the door exposed to common or public use spaces (e.g., entry or exit doors which open from the covered...
-
M302.1 General
EXCEPTION: Where weight scales contain wheelchair spaces complying with M303 and also provide a seat integral to the equipment, the scales shall not be required to comply with M302....



