include, but are not limited to – §36.403(c)(1)(i) Remodeling merchandise display areas or employee work areas in a department store; §36.403(c)(1)(ii) Replacing an inaccessible floor surface...
Search Results "End Transfer Surface"
-
Alterations To An Area Containing A Primary Function
-
704.9 Vertical separation of openings
The unexposed surface temperature limitations specified in ASTM E 119 shall not apply to the flame barriers or vertical separation unless otherwise required by the provisions of this code...
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...
-
Location
An accessible route never has curbs or stairs, must be at least 3- feet wide, and has a firm, stable, slip-resistant surface....
-
Suggested best practices for architects and other design professionals
architects and other design professionals As the construction industry works to develop standards for construction tolerances related to specific materials and applications for accessible surfaces...
-
Signage
Signs should not be made of reflective materials such as brass, silver, gold, glass, or mirrored surfaces unless there is an additional properly located sign that complies with the Standards...
-
Location
An accessible route never has curbs or stairs, must be at least 3- feet wide, and has a firm, stable, slip-resistant surface....
-
382.51 What requirements must carriers meet concerning the accessibility of airport facilities?
For foreign carriers, this requirement applies only to terminal facilities that serve flights that begin or end in the U.S (i.e., those covered by section 382.7)....
-
Undue Hardship
to six days of intermittent leave for one month, four to six days of intermittent leave each month for six months, leave required indefinitely, or leave without a specified or estimated end...
-
1. Application of Functional Performance Criteria: 508 Standards
As one commenter from the IT industry noted: “[A] supplier cannot guarantee that the functional performance criteria have been met unless the supplier controls all the components of the end-to-end...
-
2. Electronic (Digital) Level
Note: Some architects use a "rise over run" formula to calculate the slope of a surface....
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important....
-
Telescopes and Periscopes
Whenever a telescope or periscope is provided, ensure that a separate telescope or periscope is available for use from a standing position (60 inches above the floor or ground surface is...
-
Trail Slopes
Cross slopes—the side-to-side slope of a trail tread (figure 131)—provide drainage to keep water from ponding and damaging the trail, especially on unpaved surfaces....
-
2.3.2 IR Receivers
In these instances, the receiving diode can be placed within an oblong lens on the top of the headband, for presumably 360 degree reception, or appear as a rounded protuberance on the surface...
-
1. Executive Summary
access routes to be provided within pedestrian circulation paths located in the public right-of-way, and would establish proposed technical provisions for the width, grade, cross slope, and surface...
-
1. Public Right-of-Way
In particular, Kirola noted that while travelling around San Francisco, she encountered bumps and/or uneven surfaces along: (1) the east side of Fulton Street ("Fulton") between Fillmore...
-
B. The ADA Standards for Accessible Design
Section 904.2 requires that “[a]ll portions of counters required to comply with 904 shall be located adjacent to a walking surface complying with 403.” 2010 Standards § 904.2....
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
Pursuant to Chapter 3, accessible spaces must have compliant floor surfaces, compliant turning space, and compliant clear floor space, among other requirements. 2010 Standards, §§ 301-309...
-
Bradley Channel Frame Mirror 781
Bright polished stainless steel frame Roll-formed channel frame Theft resistant mounting Alternate reflective surfaces available Standard sizes available...
-
Bradley Chrome-Plated Hook and Bumper 915
Bradley Chrome-Plated Hook and Bumper Model 915 Surface-Mounted - Exposed Mounting Chrome-Plated Brass Double Hook Available BradEx Fast Ship...
-
Engaging Disability With The Gospel
But providing assistance to meet practical needs is not necessarily the first place to start, and it certainly isn’t the place to end. ...
