Where toe clearance is required at an element as part of a clear space, the toe clearance shall extend 430 mm (1.4 ft) minimum under the element....
Search Results "Clear Floor Area"
Filters
Commonly Searched Documents
-
R405.2.3 Minimum Required Depth
-
4.2.3* Wheelchair Turning Space
The space required for a wheelchair to make a 180-degree turn is a clear space of 60 in (1525 mm) diameter (see Fig. 3(a)) or a T-shaped space (see Fig. 3(b))....
-
4.2.3* WHEELCHAIR TURNING SPACE
The space required for a wheelchair to make a 180-degree turn is a clear space of 60 in (1525 mm) diameter (see Fig. 3(a)) or a T-shaped space (see Fig. 3(b))....
-
11B-608.5.3 Alternate roll-in type shower compartments
The controls, faucets, and shower spray units shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor....
-
BHMA
Builders Hardware Manufacturers’ Association 355 Lexington Avenue, 15th Floor New York, NY 10017-6603 A 156.10-2017: Power Operated Pedestrian Doors 11B-404.2.9, 11B-404.3...
-
11B-608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space. ◼...
-
USE ZONE
[DSA-AC] The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 for unrestricted circulation around the play equipment...
-
4.7.10 Diagonal Curb Ramps
The bottom of diagonal curb ramps shall have 48 in (1220 mm) minimum clear space as shown in Fig. 15(c) and (d)....
-
Diagonal Curb Ramps [§406.6]
Diagonal Curb Ramps [§406.6] If curb ramps are placed diagonally at an intersection, it is important that clear space 48” long min. is available at the bottom that is outside active...
-
inLOOP Personal Loop Digital 600
Digital inLOOP 600 is designed to provide a stable loop signal in areas up to 600 square feet, but will power areas up to 800 square feet in ideal conditions. ...
-
C. Getting Started
, and recreational areas; and toilet rooms....
-
C. Eligibility for Admission to Vocational Education Centers Based on Residence
Recipients may not establish, approve or maintain geographic boundaries for a vocational education center service area or attendance zone, (hereinafter “service area”), that unlawfully exclude...
-
11B-244.1 General
Religious practice may restrict general access to specific areas, for example a raised altar area; however access for persons with disabilities to these areas may be required....
-
11B-244.1 General
Religious practice may restrict general access to specific areas, for example a raised altar area; however access for persons with disabilities to these areas may be required....
-
11B-244.1 General
Religious practice may restrict general access to specific areas, for example a raised altar area; however access for persons with disabilities to these areas may be required....
-
Usable Door
One commenter stated that a clear definition of "usable door" is required. Response....
-
Professional Office of a Health Care Provider
The facility housing the “professional office of a health care provider” only includes floor levels housing at least one health care provider, or any floor level designed or intended for...
-
11B-306.3.1 General
Space under an element between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground shall be considered knee clearance and shall comply with Section 11B-306.3....
-
4(3)
unit that is served by the building elevator (a) is the primary entry to the unit; (b) complies with Requirements 2 through 7 with respect to the rooms located on the entry/accessible floor...
-
Do basements count in determining a facility’s story count?
As defined in the Standards, a “story” pertains to those portions of buildings “designed for human occupancy included between the upper surface of a floor and upper surface of the floor...
-
11B-306.3.1 General
Space under an element between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground shall be considered knee clearance and shall comply with Section 11B-306.3. ...
-
11B-306.3.1 General
Space under an element between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground shall be considered knee clearance and shall comply with Section 11B-306.3....
-
Continuity: ADA Standard Section 505.3
Section 505.3 covers the current ADA Standards for the continuity of handrails.
-
11B-804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1524...
