Section 305.3 covers the current ADA Standards for the required size of compliant clear floor or ground space.
Search Results "Door Clear Width"
-
Size: ADA Standard Section 305.3
-
General: ADA Standard Section 305.1
Section 305.1 of the ADA Standards covers information in the current ADA Standards for clear floor or ground space.
-
11B-309.2 Clear floor space
A clear floor or ground space complying with Section 11B-305 shall be provided....
-
11B-309.2 Clear floor space
A clear floor or ground space complying with Section 11B-305 shall be provided....
-
Technical difficulty and readily achievable
A small business has an exterior door opening that is only 26 inches wide....
-
4.34.5.1 DOORS
Doors shall not swing into the clear floor space required for any fixture....
-
9.2.2(1)
(1) Accessible sleeping rooms shall have a 36 in (915 mm) clear width maneuvering space located along both sides of a bed, except that where two beds are provided, this requirement can be...
-
Re: Caution regarding minimum Aisle Widths for aisles that serve "elements on both sides"
Thank you for pointing that out. That's an important distinction, especially in California where interpretations can vary between jurisdictions. The wording around aisles "serving...
-
Spring Hinges: ADA Standard Section 404.2.8.2
Section 404.2.8.2 covers the current ADA Standards for door and gate spring hinges.
-
Width: ADA Standard Section 405.7.2
Section 405.7.2 covers the current ADA Standards for the required width of ramp landings.
-
Continuous Width (R302.3) (Section-by-Section Analysis)
Continuous Width (R302.3) (Section-by-Section Analysis) The continuous clear width of pedestrian access routes (exclusive of the width of the curb) must be 1.2 meters (4 feet) minimum...
-
CLEAR
[DSA-AC] Unobstructed.
-
CLEAR
[DSA-AC] Unobstructed.
-
Combination Wheelchair/Horse Accessible Gates
The greatest challenge was to find a gate that allowed horses and wheelchairs to pass, but restricted all motorized traffic. The "V" gate design (see figure 5) allows wheelchairs and...
-
11B-404.2.1 Revolving doors, gates, and turnstiles
Revolving doors, revolving gates, and turnstiles shall not be part of an accessible route....
-
11B-404.2.1 Revolving doors, gates, and turnstiles
Revolving doors, revolving gates, and turnstiles shall not be part of an accessible route....
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
6. Exterior Ramp Clear Width between Handrails
6. ...are the other exterior ramps at least 36" wide (between handrails)? [ADA Stds. 4.8.3] Yes __ No __ N/A __ Comments: _________________________________________
-
407.3.6 Width
407.3.6 Width. The width of elevator doors shall comply with Table 407.4.1. EXCEPTION: In existing elevators, a power-operated car door complying with 404.2.3 shall be permitted....
-
9.5.2(2)(c)
(c) at least one toilet room for each gender or one unisex toilet room shall have a minimum clear door width of 32 in (815 mm), minimum turning space complying with 4.2.3, one water closet...
-
§ 38.113(b) Passageway
In cars where such doorways require passage through a vestibule, such vestibule shall have a minimum width of 42 inches. (see Fig. 4)...
-
1132A.3 Width and height of interior doors and secondary exterior doors
1132A.3 Width and height of interior doors and secondary exterior doors. Doors shall comply with the following:...
-
General [5.1]/ Access Aisles [5.3]
The required clear width (36 inches minimum) is specified for the clearance between the edges of fixed tables or between table edges and walls....