The bottom of diagonal curb ramps shall have a clear space 48 inches (1220 mm) minimum outside active traffic lanes of the roadway....
Search Results "Air Traffic Control Tower"
Filters
Commonly Searched Documents
-
406.6 Diagonal Curb Ramps
-
406.6 Diagonal Curb Ramps
The bottom of diagonal curb ramps shall have a clear space 48 inches (1220 mm) minimum outside active traffic lanes of the roadway....
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow. Diagonal curb ramps with flared...
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow. Diagonal curb ramps with flared...
-
407.6 Operation
At least one mode of operation shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist. The force required to activate operable parts...
-
407.9 Operation (Section-by-Section Analysis)
407.9 Operation (Section-by-Section Analysis) This section would require ICT with operable parts to provide at least one mode of operation that is operable with one hand, and...
-
407.9 Operation
At least one mode of operation shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist. The force required to activate operable parts...
-
Must operable parts be usable with a closed fist?
Closed-fist operation is a good performance test but is not required by the standards. Many types of operable parts, such as pull handles, satisfy the requirements even though they...
-
11B-809.10.7.5 Controls
Controls shall be mounted 44 inches (1118 mm) maximum above the finish floor. The force required to activate controls shall be 5 pounds (22.2 mm) maximum....
-
Elevators
reopening devices (§ 4.10.6); Door and signal timing for hall calls (§ 4.10.7); Door delay for car calls (§ 4.10.8); Illumination levels (§ 4.10.11); Car control...
-
WheelchairJimmy.com
Welcome to WheelchairJimmy.com where we intend to make travel more accessible, convenient and comforting for persons with disabilities and their families, especially those confined...
-
PUSHLiving
PUSHLiving is your gateway to accessible travel, lifestyle and shopping. Disabled Living Magazine, Accessible Travel, Inclusive Imagery, Mobility Shop. Mission statement We...
-
707.6.1 Input Controls
At least one tactilely discernible input control shall be provided for each function....
-
707.6.1 Input Controls
At least one tactilely discernible input control shall be provided for each function....
-
BEA Inc. Product Line: ACPB Access Control Push Button (Push to Exit)
BEA’s Access Control Push Button is an illuminated access control solution, including a stainless steel faceplate and brightly lit plastic button....
-
6.14.2 Gate Hardware
Gate hardware shall comply with operable controls requirements in ABAAS section 309.4 and 404.2.7....
-
1011.3 Operable Parts
Exception 2 requires trash and recycling receptacles with hinged lids and controls to keep out large animals to comply with the technical requirements for operation in 309.4 of the Architectural...
-
Kohler DTV Prompt Digital Shower Interface
The easy-to-use DTV Prompt digital shower system puts total control of your shower experience at your fingertips....
-
Specifications for Alternate Roll-in Shower Controls
Specifications for controls, faucets, and shower spray units for alternate roll-in showers are provided in section 608.5.3....
-
11B-707.6.1 Input controls
11B-707.6.1 Input controls. At least one tactilely discernible input control shall be provided for each function....
-
407.4.7.1.3 Symbols
The control button for the emergency stop, alarm, door open, door close, main entry floor, and phone, shall be identified with tactile symbols as shown in Table 407.4.7.1.3....
-
403.1 General
Where provided, biometrics shall not be the only means for user identification or control....
-
11B-407.4.7.1.1 Type
Control buttons shall be identified by raised characters or symbols, white on a black background, complying with Section 11B-703.2, and Braille complying with Section 11B-703.3....
-
11B-407.4.7.1.1 Type
Control buttons shall be identified by raised characters or symbols, white on a black background, complying with Section 11B-703.2, and Braille complying with Section 11B-703.3....
