Appendix A of the title III regulation, at 28 CFR part 36, contains the ADA Standards for Accessible Design....
Search Results "Standards Development"
Filters
Commonly Searched Documents
-
A. Statutory and Rulemaking History Up to the 2008 NPRM
-
FACTS APPLICABLE TO ALL CLAIMS
Hereafter, an "Inaccessible" curb ramp shall refer to a curb ramp that did not comply with applicable standards for accessible design (i.e., the Uniform Federal Accessibility Standards (...
-
Access to Programs and Services in Existing Facilities
When full compliance is not technically feasible, the changes must follow the Standards to the maximum extent feasible....
-
Section 1193.39 Prohibited reduction of accessibility, usability and compatibility [1193.29 in the NPRM] (Section-by-Section Analysis)
Providing that no change shall be undertaken which decreases or has the effect of decreasing accessibility is a common principle in disability access codes and standards and was borrowed...
-
§1607.7 Use of other validity studies.
While publishers of selection procedures have a professional obligation to provide evidence of validity which meets generally accepted professional standards (see section 5C above), users...
-
6. Regulatory Analyses
We request comments on the following to assess the impacts of the SNPRM: • The extent to which the AASHTO Guide, or other design guides and standards are used for shared use paths....
-
3.3.1 Research Data
Access Board staff to find as many studies as possible that were relevant to various accessibility standards....
-
Maximum side reach ranges. (Section-by-Section Analysis)
The 2004 ADAAG includes a change in the maximum height of a side reach range from 54 inches in the current ADA Standards, to 48 inches in the 2004 ADAAG. ...
-
Effective date: Triggering event. (Section-by-Section Analysis)
The information provided by commenters indicates that the first-use approach would not provide adequate guidance on when the proposed standards would apply to certain facilities and elements...
-
Operable Parts
They also suggested incorporating the provisions of section 309 of the 2010 ADA standards word for word rather than by reference, as well as new requirements to allow at least one mode of...
-
Comments
transportation commenters suggested that a longer-term solution to the problem would be to work with wheelchair manufacturers and the Department of Health and Human Services to establish standards...
-
206.2.3 Multi-Story Buildings and Facilities
Florida requirements may be waived down to the ADA Standards requirements....
-
§35.161 Telecommunication Devices for the Deaf (TDD's) (Section-by-Section Analysis)
The relay services required by title IV would involve a relay operator using both a standard telephone and a TDD to type the voice messages to the TDD user and read the TDD messages to the...
-
409.1 General (Section-by-Section Analysis)
This proposed requirement in 409.1 would be new to the 508 Standards....
-
D. Second Advance Notice of Proposed Rulemaking (2011 ANPRM)
More importantly, we needed to obtain further public comment on major issues and harmonize with the European Commission’s ICT standardization efforts that were already underway at that time...
-
A. Question 1: Applicability of Section 904.4.1’s Exception
service counter be “36 inches (915 mm) high maximum above the finish floor,” and Section 904.4.1 further requires that a sales or service counter be “36 inches (915 mm) long minimum.” 2010 Standards...
-
III-4.4600 Seating in assembly areas
The ADA accessibility standard for alterations requires wheelchair seating to be dispersed (i.e. , provided in more than one location) only in assembly areas with fixed seating for more...
-
III-1.7000 Relationship to title II
In cases where the standards differ, the stadium would have to meet the standard that provides the highest degree of access to individuals with disabilities....
-
Knee and Toe Clearance (M303.2.4)
The Access Board is considering requiring in the final standards the dimensions for toe clearance and knee clearance recommended by the Wheeled Mobility Anthropometry Project....
-
11B-703.4.2 Location
[2010 ADA Standards] 703.4.2 Location. Where a tactile sign is provided at a door, the sign shall be located alongside the door at the latch side....
-
Inpro Corporation ENDURANT® Ceiling Hung Partitions
hose-down maintenance Graffiti resistant and cleans without ghosting Repairable and renewable with easy sanding Class A Fire Rated GREENGUARD® certified Standard...
-
TownSteel CSRC Series, Grade 2, Clutched, Conical Rose Cylindrical Locks
Specification: Door Thickness 1-3/8”-2” (35mm-51mm) Backset 2-3/4” standard. 2-3/8”, 3-3/4” and 5” optional Strike ASA Strike standard, T-Strike Optional Latch bolt Stainless steel...
-
Waterless Co. No-Flush Urinal Anza 2005
Urinal to be fastened at the bottom front using standard bolts from brass urinal flange....
-
Inpro Corporation ENDURANT® Floor-Mounted Overhead-Braced Partitions
hose-down maintenance Graffiti resistant and cleans without ghosting Repairable and renewable with easy sanding Class A Fire Rated GREENGUARD® certified Standard...
