An alteration that decreases or has the effect of decreasing the accessibility of a building or facility below the requirements for new construction at the time of the alteration is prohibited...
Search Results "State Requirement"
-
11B-202.3.1 Prohibited reduction in access
-
5) Areas of rescue assistance or places of refuge
An accessible egress route or an area of rescue assistance is required for each exit required by the local fire code....
-
Guest Rooms with Mobility Features
Scoping requirements for alterations are included in 224.1.1. These scoping requirements in the 2010 Standards are consistent with the 1991 Standards....
-
202.3 Alterations
In alterations, where compliance with applicable requirements is technically infeasible, the alteration shall comply with the requirements to the maximum extent feasible. 3....
-
1011.3 Operable Parts
This section requires operable parts of outdoor constructed features to comply with the technical requirements for the height of operable parts in 309.3 of the Architectural Barriers Act...
-
Step 3: Apply the Accessibility Provisions
If the trail alignment complies with the required slope or there is no condition for an exception, compliance with the technical requirement for trail grade is required....
-
I. INTRODUCTION
and local governments (Title II), and in all employment practices of state and local government employers with 15 or more employees (Title I). ...
-
Contours of Disability in America
Carrie Buck argued before the Court that state-imposed sterilization, based on disability, was unconstitutional. The Court disagreed....
-
R401 General (Section-by-Section Analysis)
R401 General (Section-by-Section Analysis) The supplementary technical requirements in Chapter R4 apply where required by scoping requirements in Chapter R2, or where referenced by another...
-
Mansfield Urinal Suburban Commercial 475
.-2008/CSA B45.1-08 Complies with ADA requirements for accessibility...
-
Just Manufacturing 30" Stainless Steel Grab Bar
concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA Compliant Product: JGRB-30 Product Note: Grab bars meet or exceed A.D.A. requirement...
-
Just Manufacturing 42" Stainless Steel Grab Bar
concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA Compliant Product: JGRB-42 Product Note: Grab bars meet or exceed A.D.A. requirement...
-
Just Manufacturing 24" Stainless Steel Grab Bar
requirement of 250 lbs. when properly installed. A grab bar is only as strong as the anchoring devices and the wall on which it is mounted....
-
Just Manufacturing 36" Stainless Steel Grab Bar
concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA Compliant Product: JGRB-36 Product Note: Grab bars meet or exceed A.D.A. requirement...
-
Seton California Code ADA Men Rest Room Sign with Larger ISA - Black
Signs specifically meet the requirements of California's Uniform Building Code The Men's Rest Room sign is constructed of an equilateral triangle 1/4" thick with edges 12" long and...
-
2.2(b) Record of a Substantially Limiting Condition
of disability, and of potential violations of the ADA if an employer relies on such a record to make an adverse employment decision: A job applicant formerly was a patient at a state...
-
Emergency Preparedness
Making sure that people with disabilities have full access to state and local government emergency preparedness and response programs is a critical part of ADA obligations. ...
-
Sources of Technical Assistance
is available during weekdays to provide technical assistance on the ADA Standards for Accessible Design and other ADA provisions applying to businesses, non-profit service agencies and state...
-
Modifications to the Longitudinal Study
By the end of 2006, NCA had initial commitments from a number of state or federal outdoor recreation entities to provide test sites for the trail surface study, however, the down turn in...
-
Sections 35.108(d)(1)(ii) and 36.105(d)(1)(ii)—Primary Object of ADA Cases
Several commenters objected to the use of the word ‘‘cases’’ in these provisions, stating that it lacked clarity....
-
Designations and Indicators of Car Controls: ADA Standard Section 407.4.7
Section 407.4.7 covers the current ADA Standards for designations and indicators of elevator car controls.
-
Existing Elevators: ADA Standard Section 206.6.1
Section 206.6.1 covers scoping requirements in the most current ADA Standards for accessible routes existing elevators.
-
Toilet Compartments: ADA Standard Section 604.8
Section 604.8 covers the current ADA Standards for toilet compartments.
-
[ADA Title II §35.104] 1991 Standards
[ADA Title II §35.104] 1991 Standards means the requirements set forth in the ADA Standards for Accessible Design, originally published on July 26, 1991, and republished as Appendix D to...
