A 1-hour fire-resistance rating is required for smoke barriers. Exception: Smoke barriers constructed of minimum 0.10-inch thick (2.5 mm) steel in Group I-3 buildings....
Search Results "Rate of Change"
Filters
Commonly Searched Documents
-
709.3 Fire-resistance rating
-
3.1.3. Growth Rate of Auditoriums
The 2014 MPAA report provides statistics on the growth rate of auditoriums by the venue size categories. ...
-
2.7 Comparing Visual Detection Rates and High Conspicuity Ratings for Detectable Warnings
The percentages of participants giving high conspicuity ratings for each detectable warning by sidewalk combination are shown in Table 14....
-
11B-502.4 Floor or ground surfaces
Changes in level are not permitted. Exception: Slopes not steeper than 1:48 shall be permitted. [2010 ADAS] Advisory 502.4 Floor or Ground Surfaces. ...
-
11B-502.4 Floor or ground surfaces
Changes in level are not permitted. Exception: Slopes not steeper than 1:48 shall be permitted. [2010 ADAS] Advisory 502.4 Floor or Ground Surfaces. ...
-
DSA IR 11B-2: BEVELED LIP AT CURB RAMPS (with revisions issued through Jan. 2011)
General: California Building Code (CBC) Section 1127B.5 Item 3 states: "Transitions from ramps to walks, gutters, or streets shall be flush and free of abrupt changes, except that curb ramps...
-
A4.32.4 Height of Tables or Counters
A4.32.4 Height of Tables or Counters. Different types of work require different table or counter heights for comfort and optimal performance. Light detailed work such as writing...
-
A4.32.4 HEIGHT OF WORK SURFACES
Different types of work require different work surface heights for comfort and optimal performance. Light detailed work such as writing requires a work surface close to elbow height...
-
RECOMMENDED CHANGE
RECOMMENDED CHANGE Revise the Section 5.4.11 recommendation as follows: The Committee recommends transfer supports and connections contain the strength to resist vertical forces of...
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Figure 604.8.1.1 Size of Wheelchair Accessible Toilet Compartment – Drawing from the U.S. Access Board
-
Balco FMS-A Roll-Up Floor Mat with Aluminum Frame Section
Requires the Premium User plan or above. (Login or upgrade your account!) -
Balco FMS-A Floor Mat with Extruded Vinyl Edge Section
Requires the Premium User plan or above. (Login or upgrade your account!) -
Balco FMS-A Roll-Up Floor Mat Section
Requires the Premium User plan or above. (Login or upgrade your account!) -
711.4.1.1 Fire-resistance-rated assemblies
Penetrations shall be installed as tested in the approved fire-resistance-rated assembly....
-
711.3.1.1 Fire-resistance-rated assemblies
Penetrations shall be installed as tested in an approved fire-resistance-rated assembly....
-
711.4.3 Nonfire-resistance-rated assemblies
Penetrations of horizontal assemblies without a required fire-resistance rating shall meet the requirements of Section 707 or shall comply with Sections 711.4.3.1 through 711.4.3.2....
-
11B-502.4 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved. Advisory 11B-502.4 Floor or ground surfaces....
-
11B-203.9 Employee workstations
Routes; Employee Work Areas|_, 11B-207.1 _|Accessible Means of Egress; General|_, 11B-215.3 _|Fire Alarm Systems; Employee Work Areas|_, 11B-302 _|Floor or Ground Surfaces|_, 11B-303 _|Changes...
-
Extent of Application: ADA Standard Section 202.3.2
Section 202.3.2 covers the extent of application of Section 202.3
-
Guidelines for Requirement 4
Fourth, the Department has revised the specifications for changes in level at exterior patios, decks or balconies in certain circumstances, to minimize water damage....
-
Section 36.304 Removal of Barriers (Section-by-Section Analysis)
Department used the 1991 Standards as a guide to identify what constitutes an architectural barrier, as well as the specifications that covered entities must follow in making architectural changes...
