When Ramps Are Required Ramps are required on composite structures with 20 or more elevated play components and must connect to at least 25 percent of the elevated play components. ...
Search Results "Ramp Width"
Commonly Searched Documents
-
When Ramps Are Required
-
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis)
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis) Curb ramps, blended transitions, or a combination of curb ramps and blended transitions must connect the pedestrian...
-
Can handrail extensions wrap or turn?
Extensions are not required for continuous handrails along switchback or dogleg ramps or at aisle ramps serving seating in assembly areas....
-
R305.2.1 Perpendicular Curb Ramps
R305.2.1 Perpendicular Curb Ramps. On perpendicular curb ramps, detectable warning surfaces shall be placed as follows: 1....
-
R407.1 General
Ramps shall comply with R407....
- Landscape Forms Inc. Hawthorne Illuminated Bollards
- Landscape Forms Inc. FGP Guide Illuminated Bollards
- Landscape Forms Inc. 35: Guide Illuminated Bollards
- Pilot Rock Bollard Post Barricade
- Landscape Forms Inc. MutipliCITY Path Light Illuminated Bollards
-
§ 38.23(c) Vehicle ramp
(c) Vehicle ramp—...
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis) Curb ramps or blended transitions must connect the access aisle serving each accessible on-street parking space...
-
4.8.7 Edge Protection
Ramps and landings with drop-offs shall have curbs, walls, railings, or projecting surfaces that prevent people from slipping off the ramp....
-
4.8.7 EDGE PROTECTION
Ramps and landings with drop-offs shall have curbs, walls, railings, or projecting surfaces that prevent people from slipping off the ramp....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
Parking Spaces [4.6.3]
For vans with side-mounted lifts, a combined width of almost 17 feet is often needed for the deployment and use of side-mounted lifts; ADAAG requires at least 16 feet....
-
Diagonal Curb Ramps
Section 406.6 provides specifications for diagonal (or corner type) curb ramps. These curb ramps must have a 48 inch minimum clear space at the bottom....
-
11B-406.5.5 Wet conditions
Curb ramps and blended transitions shall comply with Section 11B-405.10....
-
Launch Ramps Without Boarding Piers
Launch Ramps Without Boarding Piers There are no specific provisions that address access to launch ramps without boarding piers....
-
4.2.2 Width for Wheelchair Passing
The minimum width for two wheelchairs to pass is 60 in (1525 mm) (see Fig. 2)....
-
4.2.2 WIDTH FOR WHEELCHAIR PASSING
The minimum width for two wheelchairs to pass is 60 in (1525 mm) (see Fig. 2)....
-
Priority 1: Approach & Entrance
Word Fillable Form (1.5MB) Word Non-Fillable Form (1.3MB) PDF Non-Fillable Form (0.8MB)
- Figure 405.9.1 Extended Floor or Ground Surface Edge Protection – Drawing from the U.S. Access Board
-
Built-Up Curb Ramps
A top landing at least 36” deep is required at all built-up curb ramps....