This may not always be possible in alterations, but should be avoided wherever possible. Vertical surface discontinuities between unit pavers should be minimized....
Search Results "Possible Solution"
-
R302.7.2 Vertical Surface Discontinuities
-
GUARD OR GUARDRAIL
A building component or a system of building components located at or near the open sides of elevated walking surfaces that minimizes the possibility of a fall from the walking surface to...
-
Lifting Capacity
Where possible, lifts that can support a greater weight capacity are encouraged....
-
Freedom Trax Outdoor Video
It's your portable and convenient solution to off road mobility....
-
Section 1193.23 Product design, development and evaluation (Section-by-Section Analysis)
compatibility of telecommunications equipment and customer premises equipment and incorporate such evaluation throughout product design, development, and fabrication, as early and consistently as possible...
-
Sec. 469.001(c)
(c) This chapter is intended to further the policy of this state to encourage and promote the rehabilitation of persons with disabilities and to eliminate, to the extent possible, unnecessary...
-
§100.205(b)
The developer would like the facility to be built on the site to contain as many units as possible....
-
6. Acquisition or Modification of Equipment and Devices
There are many devices that make it possible for people to overcome existing barriers to performing functions of a job....
-
Accessible Entrance
When a ramp is added to provide an accessible entrance, the slope of the ramp should be as shallow as possible but not more than 1:12....
-
Amusement Ride Seats Designed for Transfer: ADA Standard Section 1002.5
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Toilet Facilities and Bathing Facilities: ADA Standard Section 809.4
Where comparable units have vanity counter tops, accessible units should also have vanity counter tops located as close as possible to the lavatory for convenient access to toiletries....
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
407.4.7.1.2 Location
EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control as possible....
-
Transfer Height
Where possible, designers are encouraged to locate the ride seat within 17 to 19 inches above the load and unload surface....
-
Food and Beverage Service
and promising practices for paths of travel, approach to dining spaces, seating, dining table and service counter heights, and other tips for making meal and break areas as accessible as possible...
-
407.4.7.1.2 Location
EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control as possible....
-
Wall furr-out to support a grab bar when toilet is too far from the side wall
Here's a good example of one solution for a water closet that's too far from the adjacent side wall. ...
-
https://www.facebook.com/SX66France/
france--analyse-complte-des-ingrdients-des-bienfaits-et-des-rsultats-attendus- https://comunidad.espoesia.com/hrdee/sx66-france-fonctionnement-principaux-bienfaits-et-effets-secondaires-possibles-expliques...
-
Telephone Transmitter (BE1431)
Check out the data sheet to see other possible connections with the multifunctional Telephone transmitter....
-
M101.1 Purpose
The MDE Standards provide for independent access to, and use of, diagnostic equipment by patients with disabilities to the maximum extent possible....
-
Amusement Rides with Wheelchair Spaces
If possible, designers and manufacturers should incorporate more space to enhance the ease of loading and unloading and to accommodate a greater variety of personal mobility devices....
-
ii. Scoping and triggering events for EIT equipment
Scoping and triggering events for EIT equipment The Department is considering possible criteria for establishing scoping and triggering events for EIT devices and for particular features...
-
A4.10.12 CAR CONTROLS
In many cases, it will be possible to locate the highest control on elevator panels with 48 in (1220 mm) from the floor....
