The door shall not swing into or otherwise obstruct the clear floor or ground space or the turning space required by 5.1.4....
Search Results "Seating Space"
Commonly Searched Documents
-
5.1.9 Doors
-
4.6.5* Vertical Clearance
At parking spaces complying with 4.1.2(5)(b), provide minimum vertical clearance of 98 in (2490 mm) at the parking space and along at least one vehicle access route to such spaces from site...
-
406.4.1 Clear height
While the minimum height is required to be 7'-0" by this section, greater vertical clearance is required at van-accessible parking spaces, standard accessible parking spaces, the vehicular...
-
11B-904.4.2 Forward approach
Knee and toe space complying with Section 11B-306 shall be provided under the counter....
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar
-
Camping Unit
An outdoor space in a camping facility used for camping that contains outdoor constructed features, parking spaces for recreational vehicles or other vehicles, tent pads or tent platforms...
-
1134A.8, Item 3
Cabinets under lavatories are acceptable provided the bathroom has space to allow a parallel approach by a person in a wheelchair and the lavatory cabinets are designed with adaptable knee...
-
4.23.9* Medicine Cabinets
If medicine cabinets are provided, at least one shall be located with a usable shelf no higher than 44 in (1120 mm) above the floor space. The floor space shall comply with 4.2.4....
-
4.23.9* MEDICINE CABINETS
If medicine cabinets are provided, at least one shall be located with a usable shelf no higher than 44 in (1120 mm) above the floor space. The floor space shall comply with 4.2.4....
-
Camping Unit
An outdoor space in a camping facility used for camping that contains outdoor constructed features, parking spaces for recreational vehicles or other vehicles, tent pads or tent platforms...
-
11B-202.3 Alterations
Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Division 2, including Section 11B-202.4."...
-
1134A.8, Item 3
Cabinets under lavatories are acceptable provided the bathroom has space to allow a parallel approach by a person in a wheelchair and the lavatory cabinets are designed with adaptable knee...
-
Storage: ADA Standard Section 225.2
Section 225.2 covers scoping requirements in the current ADA Standards for storage.
-
11B-703.1.1.2 Inspection
The inspection shall include, but not be limited to, verification that Braille dots and cells are properly spaced and the size, proportion and type of raised characters are in compliance...
-
TECHNICALLY INFEASIBLE
alteration of a load-bearing member that is an essential part of the structural frame, or because other existing physical or site constraints prohibit modification or addition of elements, spaces...
-
3.11 Tinseltown, 651 Medford Center, Medford, Oregon
3.11 Tinseltown 651 Medford Center, Medford, Oregon - In Auditorium 6, the four (4) wheelchair spaces shall be located one row further back in the auditorium from their current location...
-
Start Outside
If there is a parking lot or garage check for the correct number of accessible parking spaces, including van-accessible spaces....
-
F. Measures Taken To Limit Impact on Small Entities
to approximately 2 percent of seats....
-
7.6. Measures Taken to Limit Impact on Small Entities
to approximately 2 percent of seats. ...
- KirbyBuilt Maxwell Recycled Plastic Picnic Table
-
Joint Use
Interior or exterior rooms, spaces, or elements that are common space available for use by all occupants of the building....
-
3. Ground and floor surface treatments
Accessible element or space ANSI A117.1 section APPLICATION 3....
-
4.1.6(1)(a)
(a) If existing elements, spaces, essential features, or common areas are altered, then each such altered element, space, feature, or area shall comply with the applicable provisions of...
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
Pursuant to Chapter 3, accessible spaces must have compliant floor surfaces, compliant turning space, and compliant clear floor space, among other requirements. 2010 Standards, §§ 301-309...