. - When installed so top of rim is 432mm (17") from finished floor....
Search Results "Floor Slope"
-
American Standard Jetbrook Urinal
-
CRL-Blumcraft® Access Control Handles 08 7100
NOTE: Models also available for floor latching....
-
Inclusion Solutions Model 2000 Voting Booth (Hard Curtain)
Product Specifications Overall height – 54.75" Writing surface height - 33.75" Clearance under writing surface (knee space) - 31" Width between legs at the floor...
-
Inclusion Solutions Model 2000 Voting Booth with Light (Hard Curtain)
Light Product specifications: Overall height – 54.75" Writing surface height - 33.75" Clearance under writing surface (knee space) - 31" Width between legs at the floor...
-
American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
For compliance with 2010 ADA Accessibility Standards, install unit so that top edge of changing table is 30-1/4" above finished floor (AFF)....
-
Willoughby Industries WAF-3300 AquaFount® Three Station Solid Surface Washfountain
A floor kit is available for an installation that requires an on-floor pedestal....
-
Willoughby Industries WWF-3603 Three Station Half Round 36" Stainless Steel Deep Bowl Washfountain
This excludes Floor Mounted (FLR) and Floor Mounted Foot Operated (FO) models....
-
Mesa Safe Company MHRC916E Electronic Hotel Safe
It comes with anchor holes that you can secure your safe onto the wall or floor to ensure proper and permanent placement to prevent removal and theft....
-
Mesa Safe Company MH101E Electronic Hotel Safe
It comes with anchor holes that you can secure your safe onto the wall or floor to ensure proper and permanent placement to prevent removal and theft. ...
-
Homeless Shelters, Group Homes, and Similar Social Service Establishments
In sleeping rooms with more than 25 beds that are covered by § 36.406(d) a minimum of five percent (5%) of the beds must have clear floor space compliant with section 806.2.3 of the 2010...
-
Scoping Requirements for Elevators
Destination-oriented elevators are different from typical elevators in that they provide a means of indicating the desired floor at the location of the call button, usually through a key...
-
F105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
Radiologic Equipment
Adequate floor space to maneuver and position stretcher. 3. Stretcher locked in place to prevent movement during lateral transfer. 4....
-
Typical Transfer Techniques: Staff Assistance and Patient Lifts
Transfer Techniques: Staff Assistance and Patient Lifts Some individuals will need additional assistance to get on and off an exam table, even if it lowers to 17‒19 inches from the floor...
-
Contrast
However, requirements for ground and floor surfaces in section 302, which require slip resistance, apply to those surfaces with detectable warnings as well....
-
224.6 Housing at a Place of Education
Kitchens within housing units containing accessible sleeping rooms with mobility features (including suites and clustered sleeping rooms) or on floors containing accessible sleeping rooms...
-
307 Protruding Objects
., higher than 27 inches from the floor) and below the standard head room clearance (80 inches), are limited to a 4 inch depth....
-
105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
thermostats and other environmental controls would meet section 100.205(c)(3)(ii) if operable parts of the controls are located no higher than 48 inches, and no lower than 15 inches, above the floor...
-
105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
205.1 General
Floor electrical receptacles shall not be required to comply with 309. 5. HVAC diffusers shall not be required to comply with 309. 6....
-
i. Medical examination and treatment tables and chairs
course of its enforcement efforts that medical and dental examination tables and chairs often are too high to be accessible, lack stabilization elements, and do not have adequate clear floor...
-
III-4.1400 Surcharges
ILLUSTRATION: The ABC pharmacy is located on the second floor of an older four-story building that does not have an elevator....
