undertaken to comply with the obligations established under this section, such changes shall be made within three years of the effective date of this part, but in any event as expeditiously as possible...
Search Results "Possible Solution"
Filters
Commonly Searched Documents
-
§35.150(c)
-
8.5 Stacks
Minimum clear aisle width between stacks shall comply with 4.3, with a minimum clear aisle width of 42 in (1065 mm) preferred where possible....
-
8.5 STACKS
Minimum clear aisle width between stacks shall comply with 4.3, with a minimum clear aisle width of 42 in (1065 mm) preferred where possible....
-
§ 35.150(c) Time period for compliance
facilities are undertaken to comply with the obligations established under this section, such changes shall be made within three years of January 26, 1992, but in any event as expeditiously as possible...
-
QUESTION: MAY CROs MAKE INTERIM RESPONSES TO COMPLAINTS?
ANSWER: *Complaints should be as detailed and specific as possible, and should be filed as soon as possible after the matter that gave rise to the complaint....
-
Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
Where possible, drainage grates should be located outside the clear ground space and elongated openings should be placed perpendicular, or as close to perpendicular as possible, to the dominant...
-
R302.7.2 Vertical Surface Discontinuities
This may not always be possible in alterations, but should be avoided wherever possible. Vertical surface discontinuities between unit pavers should be minimized....
-
Amusement Ride Seats Designed for Transfer: ADA Standard Section 1002.5
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Toilet Facilities and Bathing Facilities: ADA Standard Section 809.4
Where comparable units have vanity counter tops, accessible units should also have vanity counter tops located as close as possible to the lavatory for convenient access to toiletries....
-
11B-1002.5 Amusement ride seats designed for transfer
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
§100.205(b)
The developer would like the facility to be built on the site to contain as many units as possible....
-
Effective Communication Provisions
Some easy solutions work in relatively simple and straightforward situations....
-
Equivalent Facilitation [§103]
The question of whether an alternative solution is “equivalent” involves considerations as to whether it is just as, if not more, effective in terms of accessibility, usability, convenience...
-
GUARD OR GUARDRAIL
A building component or a system of building components located at or near the open sides of elevated walking surfaces that minimizes the possibility of a fall from the walking surface to...
-
Lifting Capacity
Where possible, lifts that can support a greater weight capacity are encouraged....
-
Door and Gate Hardware
The Board sought to limit the exception to existing doors or grilles because design solutions for accessible doors and gates are available in new construction....
-
Release of unsold accessible seats. (Section-by-Section Analysis)
While these negotiated settlement agreements and consent decrees rest on fundamental nondiscrimination principles, they represent solutions tailored to specific facilities. ...
-
2.1 What to Ask During Your First Visit
If you see problems, tell the person who is taking you around and see if they have solutions already....
-
Bed Height Fact Sheet
Simply removing the bed frame to reach the recommended height is not an acceptable solution....
-
Sec. 469.001(c)
(c) This chapter is intended to further the policy of this state to encourage and promote the rehabilitation of persons with disabilities and to eliminate, to the extent possible, unnecessary...
-
407.4.7.1.2 Location
EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control as possible....
-
407.4.7.1.2 Location
EXCEPTION: Where space on an existing car operating panel precludes tactile markings to the left of the controls, markings shall be placed as near to the control as possible....
-
Transfer Height
Where possible, designers are encouraged to locate the ride seat within 17 to 19 inches above the load and unload surface....