Accessible routes shall be provided where required by Section 11B-206.2....
Search Results "Bus Route"
Filters
Commonly Searched Documents
-
11B-206.2 Where required
-
11B-206.2 Where required
Accessible routes shall be provided where required by Section 11B-206.2....
-
206.1 General
Accessible routes shall be provided in accordance with 206 and shall comply with Chapter 4....
-
206.2 Where Required
Accessible routes shall be provided where required by 206.2....
-
1005.1 Accessible Routes
1005.1 Accessible Routes. Accessible routes serving fishing piers and platforms, including gangways and floating piers, shall comply with Chapter 4. EXCEPTIONS: 1....
-
11B-206.1 General
Accessible routes shall be provided in accordance with Section 11B-206 and shall comply with Division 4. ...
-
206.1 General
Accessible routes shall be provided in accordance with 206 and shall comply with Chapter 4....
-
11B-206.1 General
Accessible routes shall be provided in accordance with Section 11B-206 and shall comply with Division 4....
-
11B-206.1 General
Accessible routes shall be provided in accordance with Section 11B-206 and shall comply with Division 4....
-
T402.5 Surfaces
Ramp and bridgeplate surface material shall comply with T302 and extend across the full width and length of the ramp or bridgeplate.
-
Roadway resurfacing, curb ramps at crosswalks
If roadways are being resurfaced or otherwise altered as part of a BRT project, curb ramps must be installed at crosswalks that have been affected. (DOT ADA Standard 106.5.)
-
R308.1.1.2 Grade
R308.1.1.2 Grade. Parallel to the street or highway, the grade of boarding and alighting areas shall be the same as the street or highway, to the extent practicable. Perpendicular to...
-
§ 38.159(d)(4) Orientation
(4) Orientation. At least one securement device or system required by paragraph (a) of this section shall secure the wheelchair or mobility aid facing toward the front of the...
-
§ 38.159(c)(4) Ramp barriers
(4) Ramp barriers. Each side of the ramp shall have barriers at least 2 inches (50 mm) high to prevent mobility aid wheels from slipping off.
-
§ 38.161 Moveable aisle armrests
A minimum of 50% of aisle seats, including all moveable or removable seats at wheelchair or mobility aide securement locations, shall have an armrest on the aisle side which can...
-
§ 38.155 Interior circulation, handrails and stanchions
[See subsections ...]
-
B. Restrooms
B. Restrooms. The following is provided to assist manufacturers and designers to create restrooms which can be used by people with disabilities. These specifications are derived from...
-
§ 38.153(a)
(a) Floor surfaces on aisles, step treads and areas where wheelchair and mobility aid users are to be accommodated shall be slip-resistant.
-
§ 38.159(b)(9) Platform deflection
(9) Platform deflection. The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its...
-
§ 38.159(b)(3) Emergency operation
(3) Emergency operation. The lift shall incorporate an emergency method of deploying, lowering to ground level with a lift occupant, and raising and stowing the empty lift if the...
-
§ 38.159(b)(2) Controls
(2) Controls—
-
§ 38.159(c)(7) Stowage
(7) Stowage. A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps, including portable ramps stowed in the passenger area, do...
-
§ 38.159(c)(1) Design load
(1) Design load. Ramps 30 inches (760 mm) or longer shall support a load of 600 pounds (2665 N), placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches...
-
§ 38.159(b)(12) Use by standees
(12) Use by standees. Lifts shall accommodate persons using walkers, crutches, canes or braces or who otherwise have difficulty using steps. The platform may be marked to indicate a...