The space requirements for a 180-degree turn are similar across countries, ranging from 1500 mm (59 in.) in the U.K. and Canada to 1540 mm (60.6 in.) in Australia....
Search Results "Wheelchair Seating Space"
Filters
Commonly Searched Documents
-
3.3.11 180-Degree Turn
-
Station 1-Physical Characteristics
Wheel spacing-measured from the center of one outside wheel to the center of the other outside wheel....
-
Safe Harbor
Examples The 1991 Standards required one van-accessible space for every eight accessible spaces....
-
Accessible Routes
Accessible Routes An accessible route is a pathway specifically designed to provide access for individuals with disabilities, including those using wheelchairs or mobility devices....
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
F202.3 Alterations
Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Chapter 2. EXCEPTIONS: 1....
-
2.2 Key Measurement Variables and Procedures
Demographic information and wheelchair description: Approximately 30 variables recorded with a checklist, along with digital still photographs of the user and mobility device. 2....
-
You must allow service animals to accompany passengers with disabilities in the cabin
Often this will mean that the service animal will sit under the seat in front of the disabled passenger to avoid obstructing an aisle or other space....
-
Ask Questions and Provide Instructions
You can ask for and carrier personnel must be able to provide information about aircraft accessibility, seating and movable armrests, lavatory accessibility, boarding options, and storage...
-
Slope : Intercept
They form a suite of objects for installation in public space, both as a mode of critical play and critical access....
-
9. Exterior Ramps
have the following features: a. top and bottom landings that are level, at least as wide as the ramp they serve, and at least 60" long to allow for adequate maneuvering and resting space...
-
Kitchen Cabinets
With a remodel, they can be lowered to 32” a.f.f. for wheelchair users 10” removable drawer in the kick space to lower the cabinets for wheelchair users Self-closing drawers...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
II-5.2000 Methods for providing program accessibility.
ILLUSTRATION 4: A municipal performing arts center provides seating at two prices -- inexpensive balcony seats and more expensive orchestra seats....
-
(3) Adjustability: Transfer Surface Intermediate Heights
One commenter, an accessibility consultant, recommended intervals of ½ to 1 inch, indicating that ½ inch increments would be more practical to match the varying heights of wheelchairs and...
-
Size: ADA Standard Section 903.3
Benches shall have seats that are 42 inches (1065 mm) long minimum and 20 inches (510 mm) deep minimum and 24 inches (610 mm) deep maximum....
-
General: ADA Standard Section 405.1
Section 405.1 of the ADA Standards covers information in the current ADA Standards for ramps.
-
V. RESERVATION OF RIGHTS
barriers to access identified by the United States, to the extent such is readily achievable as required by applicable law, including modifying suites, and the installation of additional wheelchair...
-
Maneuvering Clearances at Doors [4.13.6]
Maneuvering Clearances at Doors [4.13.6] Pull-side clearance beyond the door swing provides space for a forward reach to door hardware....
-
§382.157(c)
., food allergies, chemical sensitivity), paraplegic, quadriplegic, other wheelchair, oxygen, stretcher, other assistive device (cane, respirator, etc.), and other disability....
-
Structural Strength: ADA Standard Section 903.6
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests. ...
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
-
11B-1009.2.6 Footrests and armrests
Footrests shall be provided and shall move with the seat. The seat shall have two armrests....
