Using the 2010 ADA Standards for Accessible Design, the minimum bench length would be 42" and the width of the clear floor space adjacent to the end of the bench would be 30"....
Search Results "Lavatory Clear Floor Space"
Filters
Commonly Searched Documents
-
Minimum Rear Wall Required.
-
§382.63(b)
(b) With respect to aircraft with only one aisle in which lavatories are provided, you may, but are not required to, provide an accessible lavatory....
-
Are accessible spaces required for tractor trailers at rest stops and other facilities?
No, the Standards exempt those spaces used exclusively for trucks, as well as buses, other delivery vehicles, law enforcement vehicles, or vehicular impound....
-
Water Closet Location.
not in the same plane as the lavatory....
-
Transit Shelters (R308.2) (Section-by-Section Analysis)
A clear space (see R404) must be provided entirely within the transit shelter....
-
1015.1 General
The technical requirements address the clear ground space (1015.2) and viewing space (1015.3) at distinct viewing locations; the turning space within viewing areas (1015.4); and the surface...
-
11B-206.2.3 Multi-story buildings and facilities
Spaces and elements located on a level not required to be served by an accessible route must fully comply with this chapter....
-
§382.63(a)
(a) As a carrier, you must ensure that aircraft with more than one aisle in which lavatories are provided shall include at least one accessible lavatory....
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
11B-806.2.4 Toilet and bathing facilities
No fewer than one water closet, one lavatory, and one bathtub or shower shall comply with applicable requirements of Sections 11B-603 through 11B-610....
-
11B-208.2 Minimum number
Where more than one parking facility is provided on a site, the number of accessible spaces provided on the site shall be calculated according to the number of spaces required for each parking...
-
TABLE OF CONTENTS
ACCESSIBLE ELEMENTS AND SPACES: SCOPE AND TECHNICAL REQUIREMENTS 4.1 Minimum Requirements 4.1.1* Application 4.1.2 Accessible Sites and Exterior Facilities: New Construction...
-
4.3.5.4 360-degree Turn
In spaces in which turning around is not critical for usability, another basis for determining the minimum floor area can be used as in the Fair Housing Accessibility Guidelines which only...
-
Boost Your Business - Chapter 3 - Path of Travel
Boost Your Business - Chapter 3 - Path of Travel
-
Play Tables
Consider the route, clear floor space and maneuvering spaces for tables intended to be accessible to individuals who use wheelchairs....
-
11B-1008.2.3 Water play components
Exceptions: Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302,...
-
§382.63(a)(1)
(1) The accessible lavatory must permit a qualified individual with a disability to enter, maneuver within as necessary to use all lavatory facilities, and leave, by means of the aircraft's...
-
606.5 Exposed Pipes and Surfaces
Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
11B-606.5 Exposed pipes and surfaces
Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
11B-606.5 Exposed pipes and surfaces
Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
-
308.3.2 Obstructed High Reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (865 mm) maximum...
-
308.3.2 Obstructed High Reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (865 mm) maximum...
-
4.34.3(2)(b) Reach Depth More Than 10 in
Where the reach depth to the operable parts of any control as measured from the vertical plane perpendicular to the edge of the unobstructed clear floor space at the farthest protrusion...
