For example, the Standards include requirements for braille and raised letter signs and cane-detectable warnings of safety hazards for persons who are blind or have low vision....
Search Results "NFSI: National Floor Safety Institute"
-
ADA Requirements
-
Nonmotorized Kick Scooters
Consumer Product Safety Commission (CPSC) reported a 13-fold increase in emergency-room-treated scooter injuries between the first and second half of 2000, from 2,820 to 37,750.(11) Operational...
-
Selection of Playgrounds
Most importantly, if there were any instances where locations on the playground were found to be in non-compliance with the accessibility or safety guidelines, the playground owner was to...
-
EVIDENCE OF AURORA'S COMPLIANCE WITH APPLICABLE LAWS AND REGULATIONS
Aurora requires the completion of annual safety training, including instruction on standard precautions—recommended by the Centers for Disease Control for the care of all patients, regardless...
-
Ramps M303:3.3, 3.3.1, 3.3.2
• Sub-Committee Recommendation: Edge Protection o Single ramp scales: 2 inch edge protection absolute is required opposite the entry ramp on the platform as a safety feature to prevent...
-
About this Study
The development guidelines require that the system provide impact safety and good accessibility....
- Metropolitan Center for Independent Living (MCIL) - Minneapolis, MN
-
§ 382.41 Stowage of personal equipment
with a disability using personal ventilators/respirators to bring their equipment, including non-spillable batteries that meet the requirements of 49 CFR 173.159(d) and any applicable FAA safety...
-
Whether the definition of ‘‘wheelchair'' includes the Segway® PT. (Section-by-Section Analysis)
See Federal Highway Administration, Characteristics of Emerging Road and Trail Users and Their Safety (Oct. 14, 2004), available at http://www.tfhrc.gov/safety/pubs/04103 (last visited June...
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADAS] 502.6 Identification. ...
-
Alterations [4.1.6(1)(f) & (k)]
Thus, the exception from the requirement for an elevator in buildings with less than 3 stories or with less than 3,000 square feet per floor applies to altered facilities as well, including...
-
Trail Facilities
For example, if a camp shelter is provided along a trail and its floor is above the ground, all hikers must be able to get inside the shelter....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADAS] 502.6 Identification. ...
-
SHOPPING CENTER (OR SHOPPING MALL)
A shopping center may include a series of buildings on a common site, connected by a common pedestrian access route on, above or below the ground floor, that is either under common ownership...
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
- Sargent 10 Line Cylindrical Lock
-
Designations: ADA Standard Section 216.2
Section 216.2 covers scoping requirements in the current ADA Standards for sign designations.
-
Path of Travel
(2) An accessible path of travel may consist of walks and sidewalks, curb ramps and other interior or exterior pedestrian ramps; clear floor paths through lobbies, corridors, rooms,...
-
Protrusion Limits: ADA Standard Section 307.2
Section 307.2 covers the current ADA Standards for protrusion limits.
-
Height: ADA Standard Section 704.4.1
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Shower Compartment Seats: ADA Standard Section 610.3
Section 610.3 covers the current ADA Standards for shower compartment seats.
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
1009.6.3 Size
Exception: The enforcing agency may reduce the size of each required area of refuge to accommodate one wheelchair space that is not less than 30 inches by 52 inches (762 mm by 1320 mm) on floors...
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...