opportunity to make the entire room or space accessible....
Search Results "Toilet Room Door"
Commonly Searched Documents
-
11B-202.3 Alterations
-
11B-308.1.1 Electrical switches
Controls and switches intended to be used by the occupant of a room or area to control lighting and receptacle outlets, appliances or cooling, heating and ventilating equipment, shall comply...
-
11B-505.2 Where required
At door landings, handrails are not required when the ramp run is less than 6 inches (152 mm) in rise or 72 inches (1829 mm) in length....
-
Section 36.406(g) Medical Care Facilities (Section-by-Section Analysis)
of any dispersion requirement may result in inappropriate concentrations of accessible rooms....
-
224.7 Housing at a place of education
Housing at a place of education shall comply with the requirements for transient lodging guest rooms in sections 224 and 806, subject to the following exceptions....
-
[F] 907.5.2.3.1 Public and common use areas
Visible alarm notification appliances shall be provided in public use areas and common use areas, including but not limited to: Band rooms Classrooms Corridors...
-
[F] 907.5.2.3.1 Public and common use areas
Visible alarm notification appliances shall be provided in public use areas and common use area, including but not limited to: Band rooms Classrooms Corridors Gymnasiums Lobbies...
-
4.16.3* Height
The height of water closets shall be 17 in to 19 in (430 mm to 485 mm), measured to the top of the toilet seat (see Fig. 29(b))....
-
4.16.3* HEIGHT
The height of water closets shall be 17 in to 19 in (430 mm to 485 mm), measured to the top of the toilet seat (see Fig. 29(b))....
-
Thresholds at Doorways [4.13.8]
Thresholds at Doorways [4.13.8] Thresholds complicate wheelchair maneuvering through doors, especially at doors equipped with closers....
-
604.8.2.3 Grab Bars
Figure 604.8.2 Ambulatory Accessible Toilet Compartment...
-
4.16.5* Flush Controls
Controls for flush valves shall be mounted on the wide side of toilet areas no more than 44 in (1120 mm) above the floor....
-
4.16.5* FLUSH CONTROLS
Controls for flush valves shall be mounted on the wide side of toilet areas no more than 44 in (1120 mm) above the floor....
-
903.3.1.1.1 Exempt locations
Automatic sprinklers shall not be required in the following rooms or areas where such rooms or areas are protected with an approved automatic fire detection system in accordance with Section...
-
2) Residential facilities/transient lodging
2) Residential facilities/transient lodging ADAAG: * Hotels, motels, dormitories, and other similar establishments: Four percent of the first 100 rooms and approximately two percent...
- Carr Corporation Folding Work Desk/Charting Stations
-
Turnstiles and Security Gates at Entrances
For example, a store that has an inaccessible turnstile at the entrance but also has an exit door (with no turnstile) located near the cash register may be able to use the exit door as an...
-
SLEEPING ACCOMMODATIONS
Rooms in which people sleep, for example, dormitory and hotel or motel guest rooms....
-
8. Reservations Made by Places of Lodging
The rule establishes requirements for reservations made by places of lodging, including procedures that will allow individuals with disabilities to make reservations for accessible guest rooms...
-
§ 36.406(c)(2) Exception
Alterations to guest rooms in places of lodging where the guest rooms are not owned or substantially controlled by the identity that owns, leases, or operates the overall facility and the...
-
Guestrooms with Roll-in Showers
Guestrooms with Roll-in Showers Common Problem: In hotels, motels, or other lodging facilities of 50 or more sleeping rooms, no rooms with roll-in showers are provided, or the roll-in...
-
Sleeping Accommodations
Rooms in which people sleep; for example, dormitory and hotel or motel guest rooms or suites....
-
Dept. of Justice Guidance Fact Sheet
Section 806 in the 2010 Standards for Accessible Design covers Transient Lodging Guest Rooms. What is a place of lodging?...
-
Directional and Informational Signs: ADA Standard Section 216.3
Section 216.2 covers scoping requirements in the current ADA Standards for directional and informational signs.