ETA Editor's Note Sections from California Building Code Chapter 10 not adopted by Division of the State Architect - Access Compliance (DSA-AC) omitted. ...
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
Raised character and Braille exit signs
-
HOUSING
A building, facility, or portion thereof, excluding inpatient health care facilities, that contains one or more dwelling units or sleeping accommodations....
-
TRANSIENT LODGING
A building or facility containing one or more guest room(s) for sleeping that provides accommodations that are primarily short-term in nature (generally 30 days or less)....
-
Error/Omission: There is no accessible route from accessible parking to an accessible entrance.
Result: A person using a wheelchair, scooter, or walker has no way of getting from the accessible parking space to the building entrance....
-
UNREASONABLE HARDSHIP
When the enforcing agency finds that compliance with the building standard would make the specific work of the project affected by the building standard infeasible, based on an overall evaluation...
-
TRANSIENT LODGING
A building or facility containing one or more guest room(s) for sleeping that provides accommodations that are primarily short-term in nature (generally 30 days or less)....
-
Literature Review
The first review of the literature focused on the effects of surface roughness on the health and safety of WC riders....
-
1009.3.1 Sloped Entries
EXCEPTION: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
1009.3.1 Sloped Entries
EXCEPTION: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
T503.4 Steps at Other Doorways
The walking surface on steps serving all other non-rail vehicle doorways shall be lighted at all times with 2 foot-candles (22 lux) minimum of illumination....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface....
-
1011.2 Clear Ground Space
This section requires a clear ground space to be provided at outdoor constructed features and includes specific provisions for the size and location (1011.2.1), surface (1011.2.2), slope...
-
4.34.6.5(8)
(8) There shall be no sharp or abrasive surfaces under sinks. Hot water and drain pipes under sinks shall be insulated or otherwise covered. Figure 51 Kitchen Sink...
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface....
-
Garage Parking
At sites that also include surface lots, a garage is treated as a separate parking facility for scoping purposes....
-
1133A.7.1 Plumbing protection
There shall be no sharp or abrasive surfaces under kitchen sinks....
-
1133A.7.1 Plumbing protection
There shall be no sharp or abrasive surfaces under kitchen sinks....
-
[A] ADDITION
[DSA-AC] An expansion, extension, or increase in the gross floor area or height of a building or facility....
-
[A] 101.1 Title
These regulations shall be known as the Building Code of [NAME OF JURISDICTION], hereinafter referred to as “this code.”...
-
1991 ADA Standards
All dimensions are subject to conventional building industry tolerances for field conditions....
-
Sec. 469.059(a)(2)
(2) the building or facility is not required to be brought into compliance because of a rule or statute, including Section 469.151....
-
EXTRAORDINARY REPAIR
The replacement or renewal of any element of an existing building or facility for purposes other than normal maintenance....
-
68.20(f) Religious Organizations
(f) Buildings or facilities of a religious organization are subject to the Act except for areas exempted under §68.30....