Where walls or partitions are not provided, the seat shall be positioned in a corner of the clear floor or ground space required by 5.3.2 for a left-hand or right-hand approach. ...
Search Results "Shall"
Commonly Searched Documents
-
5.3.3.3 Location Where Walls Not Provided
-
4.21.5 Controls
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37....
-
407.2 Contrast
Where provided, keys and controls shall contrast visually from background surfaces....
-
4.21.7 Curbs
If provided, curbs in shower stalls 36 in by 36 in (915 mm by 915 mm) shall be no higher than 1/2 in (13 mm)....
-
3.3.3 Identification of Accessible Picnic Units
Where not all picnic units are accessible, the picnic units that are accessible shall not be identified by signs at the individual units....
-
6.8.2 Grade and cross slope
The slope of a resting interval shall not be steeper than 1:33 (3 percent) in any direction....
-
4.21.5 CONTROLS
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37....
-
5.3.3.3 Location Where Walls Not Provided
Where walls or partitions are not provided, the seat shall be positioned in a corner of the clear floor or ground space required by 5.3.2 for a left-hand or right-hand approach....
-
6.3 Minimum Number
At least one beach access route shall be provided for each 1/2 mile of shoreline where required by 6.2....
-
F244.2.3.3 Tent Pads and Tent Platforms
Where provided, at least one tent pad and tent platform shall comply with 1013....
-
1014.3.2 Slope
The slope of the floor surface shall not be steeper than 1:48 in any direction....
-
M305.3.1 Horizontal Position
Where the support is horizontal, the top of the gripping surface shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum above the standing surface....
-
1016.8.3 Slope
Resting intervals shall have slopes not steeper than 1:48 in any direction....
-
M305.3.2 Vertical Position
Where the support is vertical, it shall be 18 inches (455 mm) minimum in length and the bottom end of the support shall be 34 inches (865 mm) high minimum and 37 inches (940 mm) high maximum...
-
1016.8.4 Turning Space
Where resting intervals are provided adjacent to an outdoor recreation access route, a turning space complying with 304.3.2 shall be provided....
-
68.101(c)(5)(F) Drinking fountains
(F) If drinking fountains are required by the lease agreement, or are provided to serve the leased area, at least one fountain shall comply with TAS 602....
-
§1193.51 Compatibility.
When required by subpart B of this part, telecommunications equipment and customer premises equipment shall be compatible with peripheral devices and specialized customer premises equipment...
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
11B-227.4 Food service lines
Food service lines shall comply with Section 11B-904.5....
-
11B-807.3.1 Alarms
Where audible emergency alarm systems are provided to serve the occupants of cells, visible alarms complying with Section 11B-702 shall be provided....
-
§ 37.137(b)(3) Opportunity for public comment
The submitting entity shall make its plan available for review before the plan is finalized....
-
11B-407.3.5 Door delay
Elevator doors shall remain fully open in response to a car call for 5 seconds minimum. [2010 ADAS] 407.3.5 Door Delay....
-
11B-409.3 Elevator doors
Hoistway doors, car doors, and car gates shall comply with Sections 11B-409.3 and 11B-404....
-
§ 38.123(b)
(b) Restrooms required to be accessible shall be in close proximity to at least one seating location for persons using mobility aids complying with §38.125(d) of this part and shall be connected...