A comparable line of sight, as illustrated in the figure below, allows a person using a wheelchair to see the playing surface between the heads and over the shoulders of the persons standing...
Search Results "Ramp Surface"
Commonly Searched Documents
-
Wheelchair seating locations must provide lines of sight comparable to those provided to other spectators.
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
D. Signage
be relocated to between 48 inches measured to the baseline of the lowest tactile character and 60 inches measured to the baseline of the highest tactile character above the finish floor surface...
-
A. Accessible Entrance
Accessible Entrance Having a way to get into the emergency shelter on a surface that is firm, stable, slip resistant, without steps or steep slopes, and wide enough for a person using...
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signage complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
4.4.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
11B-602.9 Pedestrian protection
When used, wing walls or barriers shall project horizontally at least as far as the drinking fountain and to within 6 inches (152 mm) vertically from the floor or ground surface....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
Alterations
An accessible path of travel may consist of walkways, parking access aisles, curb ramps, regular ramps, doorways, paths through lobbies and corridors, elevators and lifts....
-
ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...
-
Shared Use Paths: ADA Standard Section 2.
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
11B-609.3 Spacing
Section 11B-609.9 the space between the walls and the grab bar shall be 1½ inches (38 mm) minimum for a distance of 6 inches on either side of the inside corner between two adjacent wall surfaces...
- Rebuilding Together Nashville - Nashville, TN
- Rebuilding Together Twin Cities - Minneapolis, MN
-
Issue 4: Wrong pole! …Wrong message!
Since the APS is closer to the departure curb and curb ramp for crossing straight ahead (in line with the photographer’s direction of travel), a pedestrian hearing the sound from that APS...
-
Reasonable Modification of Policies, Practices, and Procedures
A young man who was recently injured and will permanently use a wheelchair needs to install a ramp to the entrance of his house. The ramp will encroach on the set-back by three feet....
-
What is a "reasonable accommodation"?
Some of the most common types of accommodations include: physical changes, such as installing a ramp or modifying a workspace or restroom; sign language interpreters for people...
-
Accessibility to Perform the Essential Functions of the Job
Examples of accommodations that may be needed to make facilities accessible and usable include: installing a ramp at the entrance to a building; removing raised thresholds...
-
Part One: The ADA’s Requirements for Small Towns
A ramp located next to the stairs to this town hall provides an accessible entrance. 1 The term "towns" is used in this publication to refer to all small local governments, towns, and...
-
10 - foot straightedge method
For ramps ACI 117 refers to RMS Levelness tolerance as defined in paragraph 4.11 in ASTM E - 1486....