In the diagram below, the upper wheelchair illustrates a typical side transfer, which may optionally utilize a transfer board....
Search Results "Flared Side"
-
How to Measure Transfer Surface Height
-
Forward and Side Approaches
At most elements, clear floor space can be positioned for either a forward approach or a side approach....
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
considering whether the above cross section dimensions would be appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
5.1.4 Transfer Surface Height Measurement for M301 and M302
Rationale for final recommendation Having an accessible transfer surface height is critical to facilitate independent patient transfers to equipment used by patients both in a supine, side-lying...
-
How Can You Overcome These Barriers to Work with Your Providers?
There are many things that a person with a disability can do to improve his or her quality of health care and break down the barriers that compromise care. The following suggestions...
-
Side guard protocol
Percentage of subjects that were able to attain a certain height in the side guard protocol Height (in) % Subjects Side guard 10...
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
-
5.4.3 Transfer Support Height for M301 and M302
whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
Sides of Curb Ramps [§406.3]
Sides of Curb Ramps [§406.3] Curb ramps can have returned sides, but a top landing is required under all conditions to allow maneuvering to and from the run....
-
Georgia-Pacific Compact® Brushed Steel Finish Side-By-Side Double Roll Bathroom Tissue Dispenser 56796
Attractive Compact double roll, side-by-side coreless bathroom tissue dispensing system provides up to six times the capacity of single standard 2-ply rolls while maintaining your professional...
-
Brewer Access™ High-Low Exam Table
The Brewer Company leads the industry in innovation through our comprehensive line of power procedure tables, exam tables, seating, lighting, and broad line of durable medical...
-
Behavioral Safety Products #GB350 Suicide Resistant Safety Grab Bar with Full Closure Plate
Product Description We offer this suicide resistant grab bar in seven lengths: 18", 24", 30", 32", 36", 42", and 48". All lengths except for the 18" and 32" are available for...
-
Brey-Krause Concealed Mounting Security / Anti Suicide Grab Bars
The concealed mount anti-ligature grab bars are fabricated from 18 gauge stainless steel. The flange is constructed from 11 gauge stainless steel and is three inches in diameter....
-
M305.2.2 Length
The length of transfer supports shall comply with M305.2.2.1 or M305.2.2.2.
-
M301.2.1 Height
The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer...
-
5.1 Transfer Surface Height Recommendations
The height provision is the same for MDE used by patients in supine, prone, or side-lying positions (M301) and patients in seated positions (M302)....
-
11B-1002.4.4.2 Side entry
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
-
11B-1002.4.4.2 Side entry
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
-
11B-1002.4.4.2 Side entry
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
-
11B-406.5.3 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding any flared sides, or the blended transition leading to the landing....
