Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
Search Results "Hybrid Surface System"
-
11B-903.4 Back support
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
Passing Spaces [1017.4]
Nominally planar means on the same nominal table surface (same nominal geometric surface plane) and the slopes of the table surface correspond to the running slope and cross slope of the...
-
Preliminary Guidelines for Vitri-Turf SEWF Installation
Do not saturate the surface with these lubricants. After compaction, thickness will be approximately 40 mm (1.6 in.)....
-
Amusement Ride
A system that moves persons through a fixed course within a defined area for the purpose of amusement....
-
T603.1 General
Wheelchair securement systems in non-rail vehicles, including attachments, shall comply with T603....
-
T404.1 General
Boarding and alighting at boarding platforms in level boarding bus systems shall comply with T404....
-
409.4.7 Emergency Communications
Emergency two-way communication systems shall comply with 409.4.7....
-
106.5.7 Amusement Ride
A system that moves persons through a fixed course within a defined area for the purpose of amusement....
- CS SofStop Pocket Door Kit
-
Section 35.161 Telecommunications (Section-by-Section Analysis)
In § 35.161(b), the Department addresses automated attendant systems that handle telephone calls electronically. ...
- Spectrum Industries Inc. Freedom One Sit-to-Stand Lectern
-
4.3 Diagnostic Imaging Equipment
4.3 Diagnostic Imaging Equipment Diagnostic imaging equipment encompasses a broad range of technologies comprised of integrated systems of components and accessories with diverse designs...
-
TTYs: ADA Standard Section 217.4
Section 217.4 covers scoping requirements in the current ADA Standards for TTYs.
-
11B-810.6.2 Routes and destinations
Signs covered by this requirement shall, to the maximum extent practicable, be placed in uniform locations within the system....
-
1003.1 Applicability
The general requirements specified in Sections 1003 through 1015 shall apply to all three elements of the means of egress system, in addition to those specific requirements for the exit...
-
11B-810.6.2 Routes and destinations
Signs covered by this requirement shall, to the maximum extent practicable, be placed in uniform locations within the system....
-
What other considerations are significant for persons with disabilities?
Thus, walks surfaced in these materials could not constitute an accessible route....
-
Questionnaire Data
Table 7 displays the results from the surface questionnaire for all surfaces....
-
904 Sales and Service Counters
Specifications are provided for the counter surface height of check-out aisles, including the height of counter edge protection, which is limited to 2 inches above the counter surface (904.3.2...
-
Manual vs. Power (Questionnaire Data)
It should be noted that even though manual WC users had higher vibrations for all engineered surfaces, on average they rated all surfaces better than power chair users....
-
Do basements count in determining a facility’s story count?
As defined in the Standards, a “story” pertains to those portions of buildings “designed for human occupancy included between the upper surface of a floor and upper surface of the floor...
-
DETECTABLE WARNING
A standardized surface feature built in or applied to walking surfaces or other elements to warn of hazards on a circulation path. Advisory Definition of DETECTABLE WARNING....
-
ASME
This means of communication must connect with emergency or authorized personnel and not an automated answering system. The communication system must be push button activated....