Section 216.2 covers scoping requirements in the current ADA Standards for sign designations.
Search Results "Door Clear Width"
Filters
Commonly Searched Documents
-
Designations: ADA Standard Section 216.2
-
Application Based on Building or Facility Use: ADA Standard Section 201.2
Section 201.2 covers the application of the most current requirements based on the building or facility use.
-
11B-216.4.2 Areas of refuge and exterior areas for assisted rescue
Signs required by Chapter 10, Section 1009.9 at doors to areas of refuge and exterior areas for assisted rescue shall comply with Sections 11B-703.1, 11B-703.2, 11B-703.3, and 11B-703.5...
-
Transit Shelters (R308.2) (Section-by-Section Analysis)
A clear space (see R404) must be provided entirely within the transit shelter....
-
304.3.2 T-Shaped Space
Each arm of the T shall be clear of obstructions 12 inches (305 mm) minimum in each direction and the base shall be clear of obstructions 24 inches (610 mm) minimum....
-
304.3.2 T-Shaped Space
Each arm of the T shall be clear of obstructions 12 inches (305 mm) minimum in each direction and the base shall be clear of obstructions 24 inches (610 mm) minimum....
-
304.3.2 T-Shaped Space
Each arm of the T shall be clear of obstructions 12 inches (305 mm) minimum in each direction and the base shall be clear of obstructions 24 inches (610 mm) minimum....
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable base cabinets...
-
Access Board: Signs
-
Developing a plan based on priorities
Priority 1: Getting through the Door The first priority is to make sure individuals with disabilities can physically enter the facility as independently as possible....
-
D5. Raised Threshold
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
1134A.8, Item 4.1
The space beneath the lavatory shall be left clear and unobstructed;...
-
1011.2.2 Surface
This section requires the surface of the clear ground space to be firm and stable....
-
1134A.8, Item 4.1
The space beneath the lavatory shall be left clear and unobstructed;...
-
5.4.2.2 Transfer and Positioning Support Length Recommendations for Imaging Equipment with Transfer Surfaces
recommendation A transfer support (for transfer surfaces less than or equal to 24” deep) is to extend horizontally along the side of the patient scanning/imaging table at least the minimum width...
-
R306.3.1 Separation
European and Australian roundabouts provide a 610 mm (24 inch) width of tactile surface treatment from the centerline of the curb ramp or blended transition across the full width of the...
-
Station 2-Three-Point Turn
Designers can use this information to select shared use path widths and, if necessary, build wider turnaround areas, so that users can execute U-turns within the confines of the path....
-
Re: Co-sharing of Accessible Parking access Aisles by adjacent elevator door allowed?
Pedestrians in the elevator would be stepping directly into a vehicular way upon exiting the elevator cab. How would you address the requirement for detectable warnings? Changes in...
-
Wayfinding is more than just graphics (slides 2 – 4)
And so we could be a little more clear about the audio cues that we’re providing in a way finding system....
-
Seton Economy Braille Signs - Men's Restroom with ISA
Injection molded plastic signs feature easy-to-read messages, clear graphics and Grade 2 Braille Signs measure 6"W x 9"H x 1/8" Available in Gray or ADA Blue Double-sided tape...
-
Seton Economy Braille Signs - Women's Restroom with ISA
Injection molded plastic signs feature easy-to-read messages, clear graphics and Grade 2 Braille Signs measure 6"W x 9"H x 1/8" Available in Gray and ADA Blue Double-sided tape...
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
-
Sec.36.304(d)(2)
Such measures include, for example, providing a ramp with a steeper slope or widening a doorway to a narrower width than that mandated by the alterations requirements....
-
M305.2.3 Height
EXCEPTION: Where the width of the transfer surface for imaging beds exceed 24 inches (610 mm), the tops of the gripping surfaces shall be permitted to be 3 inches (75 mm) minimum and 6 inches...
