Bradley Chrome-Plated Robe Hook Model 9118 Surface-Mounted - Exposed Mounting Heavy-Duty Chrome-Plated Brass Satin Chrome Finish available using -81 Available...
Search Results "Surface Slope"
- Bradley Chrome-Plated Robe Hook 9118
- Bradley Contemporary Series Chrome Plated Double Robe Hook 912
- Bradley Channel Frame Mirror with Shelf 7815
- Bradley 1 Station Verge Lavatory System LVRD1
-
M307 Operable Parts
Patients who are blind or have low vision have difficulty distinguishing a flat membrane button or similar control unless it is tactilely discernible from the surrounding surface and any...
- Wikk Industries Inc. Bollard With Push Plate PART # BPFSMPREP36PCCL
-
Introduction
When the slope of a sidewalk that is an accessible route becomes steeper than 1 to 20, railings and edge protection are required for safe use....
-
11B-604.3.2 Overlap
2-11B, dated 9/9/14, which includes the following interpretation of Subsection 11B-604.3.2: Showers are fixtures including a 30 inch x 60 inch clear receptor with a minimum/maximum slope...
-
11B-604.3.2 Overlap
2-11B, dated 9/9/14, which includes the following interpretation of Subsection 11B-604.3.2: Showers are fixtures including a 30 inch x 60 inch clear receptor with a minimum/maximum slope...
-
1150A.1 General
Test No. 1 -- Individual Building Test may only be used if the site has terrain over 15 percent slope. Test No. 3 -- Unusual Characteristics Test may be used if applicable....
- Bradley Concealed Mounting Chrome-Plated Robe Hook 9119
- Bradley Stainless Steel Clothes Hook 9111
- Wikk Industries Inc. Bollard With Push Plate Part #BPRT1435CSFT32D (630)
- Bradley Stainless Steel Towel Hook 9314, 9315
-
Feature 1 - Parking and Passenger Drop-Off Areas
In order to be usable, the access aisle must be level, clear of gravel or mud, and the surface must be in good condition without wide cracks or broken pavement....
-
Vanity Counter Tops
The Board has removed the minimum surface requirement (2 square feet) for vanity counter tops....
-
Curb Ramps at Marked Crossings and Vehicular Lanes
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
Benches
If benches are located in wet areas, the surface must be slip-resistant and designed not to accumulate water....
-
224.6 Housing at a Place of Education
suites and clustered sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 and kitchen work surfaces...
-
3. Buttock-Popliteal Length
The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
-
3.3 Data Sources
Early on, it became clear that some Committee members were unfamiliar with issues raised during transfers from a wheelchair or scooter onto a surface such as an examination table....
-
4.3.3 Imaging Equipment Used for Interventional and Biopsy Procedures with Sedated Patients
patients undergoing these procedures receive some form of sedation prior to transfer.CC When sedated, all patients – regardless of their physical abilities – are assisted onto the transfer surface...
-
Beach Access Routes
A beach access route is a continuous, unobstructed path that crosses the surface of the beach and provides pedestrians access to the water....
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...