Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
Search Results "Supplemental Requirement"
Filters
Commonly Searched Documents
-
General: ADA Standard Section 803.1
-
11B-812 Electric vehicle charging stations
However, the absence of scoping or technical requirements in the Standards would make it difficult to conclude what that means....
-
11B-802.1.2 Width
Figure 11B-802.1.2 (b) depicts paired wheelchair spaces requiring a total of 66 inches in width....
-
11B-404.3.5 Controls
Doors should not swing into the required clear floor or ground space for the operating device. ◼...
-
11B-306.1 General
When determining clearance under an object for required turning or maneuvering space, care should be taken to ensure the space is clear of any obstructions. ◼...
-
1.1.3 Scope
In alteration projects, these provisions apply to the area of new work, and include the path of travel requirements found in Section 11B-202.4. ◼...
-
HOUSING AT A PLACE OF EDUCATION
The requirements in CBC Chapter 11A for privately owned covered multifamily dwellings shall be applied in lieu of 11B-224.7.2 for accessible dwelling units with adaptable features. ◼...
-
Line of Sight and Dispersion of Wheelchair Spaces in Assembly Areas
Sections 221.2.3 and 802.2 of the 2010 Standards add specific technical requirements for providing lines of sight over seated and standing spectators and also require wheelchair spaces and...
-
E. Paperwork Reduction Act
The Department may not impose a penalty on persons for violating information collection requirements when an information collection required to have a current OMB control number does not...
-
Providing Comforts and Conveniences—Constructed Features
The requirements for constructed features are addressed in sections 3, 4, and 5 of FSORAG....
-
Assistive listening systems. (Section-by-Section Analysis)
Although there were requests for adjustments in the scoping requirements from advocates seeking increased scoping requirements, and from large venue operators seeking fewer requirements,...
-
Toilet Buildings and Pit Toilets
Grab bars must comply with the reach ranges required in ABAAS, section 308, and explained in "Reach Ranges and Operability Requirements" of this guidebook....
-
Title II Public Entity Facilities Compliance Fact Sheet
Regardless of that, a public entity is required to take any other action that would not trigger this limitation and ensure program accessibility....
-
Accessible Routes from Site Arrival Points and Within Sites
The 1991 Standards require that curb ramps be provided wherever an accessible route crosses a curb....
-
Historic Preservation Programs
Narrow application of the special limitation is justified because of the inherent flexibility of the program accessibility requirement....
-
Examples and Resources to Support Criminal Justice Entities in Compliance with Title II of the ADA
this guidance discusses are restatements of existing requirements from Title II of the Americans with Disabilities Act, 42 USC 12131-12134, and its implementing regulations at 28 CFR pt...
-
Section 610 Review
The Department also is required to conduct a periodic regulatory review pursuant to section 610 of the RFA, as amended by the SBREFA....
-
407.12 Reach Height (Section-by-Section Analysis)
407.12 Reach Height (Section-by-Section Analysis) This section proposes requirements for the height of side and forward reaches that would enable persons using wheelchairs or other mobility...
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....
-
About this Guide
This guide explains requirements of both standards, which are jointly referred to as the “ADA Standards” or “the standards.”...
-
M304 Diagnostic Equipment Used by Patients in Standing Position
The proposed standards do not require diagnostic equipment to support more than one position....
-
Section 610 Review
The Department is also required to conduct a periodic regulatory review pursuant to section 610 of the RFA....
-
Communication. (Section-by-Section Analysis)
Several large disability advocacy organizations commented on the 2004 ADAAG section 232.2.2 requirement that at least 2 percent of the general holding cells and housing cells must be equipped...
-
11B-604.3.2 Overlap
routes, clear floor space and clearances required at other fixtures, and the turning space....