Florida requirements may be waived down to the ADA Standards requirements....
Search Results "Qualification Standard"
-
206.2.3 Multi-Story Buildings and Facilities
-
§35.161 Telecommunication Devices for the Deaf (TDD's) (Section-by-Section Analysis)
The relay services required by title IV would involve a relay operator using both a standard telephone and a TDD to type the voice messages to the TDD user and read the TDD messages to the...
-
T402 Ramps and Bridgeplates
important that any potential revision of requirements for minimum design loads for ramps be coordinated with design loads for public lifts specified in the Federal Motor Vehicle Safety Standards...
-
409.1 General (Section-by-Section Analysis)
This proposed requirement in 409.1 would be new to the 508 Standards....
-
D. Second Advance Notice of Proposed Rulemaking (2011 ANPRM)
More importantly, we needed to obtain further public comment on major issues and harmonize with the European Commission’s ICT standardization efforts that were already underway at that time...
-
Water Hydrants
Standard handpumps require a force greater than 5 pounds (2.2 newtons) and a long reach to operate....
-
A. Question 1: Applicability of Section 904.4.1’s Exception
service counter be “36 inches (915 mm) high maximum above the finish floor,” and Section 904.4.1 further requires that a sales or service counter be “36 inches (915 mm) long minimum.” 2010 Standards...
-
EXHIBIT A: EDX WEBSITE ACCESSIBILITY POLICY
Guidance on Applying WCAG 2.0 to Non-Web Information and Communications Technologies (“WCAG2ICT”) for non-web software and content; and the Digital Accessibility Information System (“DAISY”) Standard...
-
III-4.4600 Seating in assembly areas
The ADA accessibility standard for alterations requires wheelchair seating to be dispersed (i.e. , provided in more than one location) only in assembly areas with fixed seating for more...
-
III-1.7000 Relationship to title II
In cases where the standards differ, the stadium would have to meet the standard that provides the highest degree of access to individuals with disabilities....
-
F - number system
F - number system The F - number system, ASTM E 1155, Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers, was developed primarily to aid in the construction...
-
Knee and Toe Clearance (M303.2.4)
The Access Board is considering requiring in the final standards the dimensions for toe clearance and knee clearance recommended by the Wheeled Mobility Anthropometry Project....
-
11B-703.4.2 Location
[2010 ADA Standards] 703.4.2 Location. Where a tactile sign is provided at a door, the sign shall be located alongside the door at the latch side....
-
A. Statutory and Rulemaking History Up to the 2008 NPRM
Appendix A of the title III regulation, at 28 CFR part 36, contains the ADA Standards for Accessible Design....
-
FACTS APPLICABLE TO ALL CLAIMS
Hereafter, an "Inaccessible" curb ramp shall refer to a curb ramp that did not comply with applicable standards for accessible design (i.e., the Uniform Federal Accessibility Standards (...
-
Access to Programs and Services in Existing Facilities
When full compliance is not technically feasible, the changes must follow the Standards to the maximum extent feasible....
-
2. Justification for Applying WCAG 2.0 to Non-Web ICT
We find support for our approach from two other sources, namely the European Commission’s Standardization Mandate M 376 (M376) of March 2012 and the World Wide Web Consortium’s WCAG2ICT...
- Willoughby Industries ASHS-1013-06-15-HC Ligature-Resistant 15" wide Lavatory
- Delta Single Handle Pull-Out Kitchen Faucet 472-DST
- BEST Door Lever Hardware Cylindrical Locks - 5K
- Trimco 1069 Series ADA Pocket Door Pull
- Willoughby Industries DF-1015-96-HC Rear Mounted Drinking Fountain
- Inpro Corporation IPC® Designer Kickplates
- SafePath EZCurb™ Wheelchair Ramps - Vertical Barrier Removal