Chapter 3 shall apply to ICT where required by 508 Chapter 2 (Scoping Requirements), 255 Chapter 2 (Scoping Requirements), and where otherwise referenced in any other chapter of the 508 Standards...
Search Results "Applicable Standard"
Filters
Commonly Searched Documents
-
301.1 Scope
-
4.17.4 Toe Clearances
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....
-
4.17.4 TOE CLEARANCES
In standard stalls, the front partition and at least one side partition shall provide a toe clearance of at least 9 in (230 mm) above the floor....
-
Stability or Stable Surface
stable surface is one that remains unchanged by contaminants or applied force, so that when the contaminant or force is removed, the surface returns to its original condition (2010 ADA Standards...
-
11B-703.4.1 Height above finish floor or ground
[2010 ADA Standards] 703.4.1 Height Above Finish Floor or Ground....
-
11B-607.2 Clearance
[2010 ADA Standards] 607.2 Clearance. Clearance in front of bathtubs shall extend the length of the bathtub and shall be 30 inches (760 mm) wide minimum....
-
11B-407.3.4 Door and signal timing
[2010 ADA Standards] 2. Destination-oriented elevators shall not be required to comply with 407.3.4....
-
11B-806.3 Guest rooms with communication features
For headset or external amplification system compatibility, a standard subminiature jack installed in the telephone will provide the most flexibility. ◼...
-
11B-705.1.1.2 Dome spacing
[2010 ADA Standards] 705.1.2 Dome Spacing....
-
11B-810.2.2 Dimensions
Access Board's Note to Reader: The Department of Transportation's ADA Standards indicate that compliance is required to the extent construction specifications are within a public entity's...
-
Stanley Magic-Force™ Full or Low Energy Swing Door Operator
It is ideal for applications such as supermarkets, department stores, airports, office buildings, public buildings, schools and universities. ...
-
Final Regulatory Impact Analysis
The Final RIA embodies a comprehensive benefit-cost analysis of the final rules for both title II and title III and assesses the incremental benefits and costs of the 2010 Standards relative...
-
Section 36.103 Relationship to Other Laws (Section-By-Section Analysis and Response to Comments)
Paragraph (a) provides that, except as otherwise specifically provided by this part, the ADA is not intended to apply lesser standards than are required under title V of the Rehabilitation...
-
Organization of This Rule
Throughout this rule, the original ADA Standards, which are republished as Appendix D to 28 CFR part 36, will be referred to as the ‘‘1991 Standards.''...
-
E102.5 IETF (Section-by-Section Analysis)
This standard describes how to carry real-time text conversation session contents in RTP packets....
-
Accessible Fishing Piers and Platforms
Sections 237 and 1005 of the 2010 Standards require at least twenty-five percent (25%) of railings, guards, or handrails (if provided) to be at a 34-inch maximum height (so that a person...
-
5.4.11 Transfer Support Structural Strength Recommendations for M301 and M302
The proposed technical criteria originated from provisions for grab bars in the 2010 Standards....
-
8.3 Alternate Means of Access
Although current technical requirements may prevent compliance with recommended access standards (see Section 7 for examples), Committee members aimed to encourage manufacturers and developers...
-
Overview
Throughout this NPRM, the current, legally enforceable ADA Standards will be referred to as the "1991 Standards," 28 CFR part 36, App....
-
Dept. of Justice Guidance Fact Sheet
facility or part of the facility is readily accessible to and usable by individuals with disabilities, if the construction was commenced after January 26, 1992 (Section 35.151 of the 2010 Standards...
-
A. Measuring Slope and Cross Slope
:slopes tilting side to side) are within the limits allowed by the ADA Standards for Accessible Design ("Standards"). There are three primary ways to determine a given slope: 1....
-
Introduction
The new rules clarify issues that arose over the previous 20 years and contain new requirements, including the 2010 ADA Standards for Accessible Design (2010 Standards)....
-
6.1 Universal Receiver: Recommendations
6.1 Universal Receiver: Recommendations The need for a universal receiver was highlighted when it was suggested that standardized transmitting characteristics for both FM and IR ASL be...
-
SCOTT JOHNSON v. STARBUCKS CORPORATION - AMICUS BRIEF
One of those claims posits that Defendants have violated Section 904.4.1 of the 2010 ADA Standards for Accessible Design (2010 Standards) because they have failed to provide 36 inches of...
