The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
Search Results "Sloped Area"
Filters
Commonly Searched Documents
-
11B-809.10.6.2 Slope
-
Assembly Area
For the purposes of these requirements, assembly areas include, but are not limited to, classrooms, lecture halls, courtrooms, public meeting rooms, public hearing rooms, legislative chambers...
-
Wheelchair Spaces
The 33-inch minimum width for spaces provides extra width for maneuvering within a confined area....
-
4.1.6(3)(f) Assembly Areas
(f) Assembly Areas:...
-
405 Ramps
Revisions made to this section include: a new exception for ramps in assembly areas (405.1) removal of an exception for ramp slopes in historic facilities (405.2)...
-
206.2.6 Performance Areas
206.2.6 Performance Areas....
-
206.2.6 Performance Areas
Where a circulation path directly connects a performance area to an assembly seating area, an accessible route shall directly connect the assembly seating area with the performance area....
-
F206.2.6 Performance Areas
Where a circulation path directly connects a performance area to an assembly seating area, an accessible route shall directly connect the assembly seating area with the performance area....
-
11B-504.4 Tread surface
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved....
-
Areas of Refuge (Preamble, Section-by-Section Analysis)
- Areas of refuge (areas with direct access to a stairway, and where people who cannot use stairs may await assistance during a emergency evacuation) will be required, as proposed, but the...
-
806.2.1 Living and Dining Areas
806.2.1 Living and Dining Areas. Living and dining areas shall be accessible....
-
11B-403.5 Clearances
Exception: Within employee work areas, clearances on common use circulation paths shall be permitted to be decreased by work area equipment provided that the decrease is essential to the...
-
Section 35.151(g) Assembly areas
Section 35.151(g) Assembly areas In the NPRM, the Department proposed Sec. 35.151(g) to supplement the assembly area requirements of the 2004 ADAAG, which the Department is adopting as...
-
Digital inclinometers (SmartTool®)
Digital inclinometers (SmartTool®), while slightly more expensive than standard levels, are easy to calibrate and use and can measure slopes in degrees, percent, and fractions per foot....
-
Definition of "Assembly Area"
It was suggested that the definition of "assembly area" should more clearly address the types of facilities covered....
-
1.6.17 Sterile Area.
1.6.18 Sterile Area....
-
Viewing Areas
[See subsections ...]
-
Visiting Areas: ADA Standard Section 232.5
Section 232.5 covers scoping requirements in the current ADA Standards for visiting areas.
-
Floor or Ground Surfaces: ADA Standard Section 304.2
Section 304.2 covers the current ADA Standards for the ground surfaces of a turning space.
-
203.10 Raised Refereeing, Judging, and Scoring Areas
203.10 Raised Refereeing, Judging, and Scoring Areas....
-
11B-304.2 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved. Advisory 11B-304.2 Floor or ground surface Exception....
-
F247.4.3 Viewing Areas
Viewing areas provided on trails shall comply with F246.2 and F246.3....
-
F247.4.3 Viewing Areas
Viewing areas provided on trails shall comply with F246.2 and F246.3....
-
Slope and Rise [4.8.2]
There are trade-offs between the two: a steeper slope makes the run shorter, while a more gradual slope increases the length....