Signs required by Chapter 10, Section 1008.1.9.7, item 5.1 at doors with delayed egress locks shall comply with Sections 11B-703.1 _|Signs; General|_ 11B-703.2 _|Signs; Raised Characters...
Search Results "Raised Crossing"
Commonly Searched Documents
-
11B-216.4.4 Delayed egress locks
-
11B-216.4.4 Delayed egress locks
Signs required by Chapter 10, Section 1010.1.9.7, Item 6.4 at doors with delayed egress locks shall comply with Sections 11B-703.1 _|Signs; General|_ 11B-703.2 _|Signs; Raised Characters...
-
11B-403.3 Slope
The cross slope of walking surfaces shall not be steeper than 1:48....
-
11B-403.3 Slope
The cross slope of walking surfaces shall not be steeper than 1:48....
-
1018.4 Clear Width
EXCEPTION: At dune crossings, the clear width of beach access routes that are not removable shall be permitted to be reduced to 48 inches (1220 mm) minimum....
-
6.6 Clear Width
Exception: At dune crossings, the clear width of beach access routes that are not removable shall be permitted to be reduced to 48 inches (1220 mm) minimum....
-
1018.4 Clear Width
EXCEPTION: At dune crossings, the clear width of beach access routes that are not removable shall be permitted to be reduced to 48 inches (1220 mm) minimum....
-
Location
Location Pushbutton-integrated APS rely on relative proximity to the crossing location, not on difference in sounds, to clarify which street crossing is being signaled....
-
407.2.3.1 Floor Designation
407.2.3.1 Floor Designation. Floor designations complying with 703.2 and 703.4.1 shall be provided on both jambs of elevator hoistway entrances. Floor designations shall be provided...
-
407.2.3.1 Floor Designation
Floor designations complying with 703.2 and 703.4.1 shall be provided on both jambs of elevator hoistway entrances. Floor designations shall be provided in both tactile characters...
-
407.2.3.1 Floor Designation
Floor designations complying with 703.2 and 703.4.1 shall be provided on both jambs of elevator hoistway entrances. Floor designations shall be provided in both tactile characters...
-
Appendix 1: ADA Accessibility Survey Instructions: Curb Ramps
[See subsections ...]
-
Q11: Utility Trench Work and Curb Ramp Compliance
If the utility work impacts the curb at a pedestrian street crossing where no curb ramp exists, the work affecting the curb falls within the definition of "alteration," and a curb ramp must...
-
D. What Does Title II of the ADA Require with Respect to Curb Ramps at Pedestrian Crossings?
Title II of the ADA requires state and local governments to make pedestrian crossings accessible to people with disabilities by providing curb ramps.2 This requirement applies if your state...
-
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces....
-
A10.3.1(7) Route Signs
One means of making control buttons on fare vending machines usable by persons with vision impairments is to raise them above the surrounding surface....
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces....
-
1.2.2
When flatness of cross slope for an accessible surface other than a ramp is measured according to Section 1.1.6 at least 80% (rounded to the nearest whole number) of the measurements should...
-
e-v
Are raised letters and Braille characters used to identify each floor button and each control? [ADA Standards § 4.10.12] Yes No...
-
1016.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1016.7.1) and cross slope (1016.7.2) of outdoor recreation access routes....
-
406.5 Location
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides....
- seca 664 - electronic wheelchair scale_without comments - seca1840
-
406.5 Location
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides....