In the MDE NPRM, the Access Board did not provide any specific requirements for clearances around the transfer support....
Search Results "Horizontal Standing Support"
Commonly Searched Documents
-
M305.2.7 Clearance (Section-by-Section Analysis)
-
M305.2.8 Fittings (Section-by-Section Analysis)
The MDE NPRM proposed to require that transfer supports not rotate in their fittings (proposed M305.2.3). Five commenters addressed this provision....
-
d. Unobstructed Transfer
Six of the eleven commenters who responded to this question supported permitting equipment parts to extend up to three inches horizontally beyond the edge of the transfer surface....
- Access Board: Tactile Sign Scoping
-
M305.2.2 Length
The length of transfer supports shall comply with M305.2.2.1 or M305.2.2.2....
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports....
-
221 Assembly Areas
Readily removable seats may be installed in wheelchair spaces when the spaces are not required to accommodate wheelchair users. 221.2.3.1 Horizontal Dispersion....
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
M305.2.3 Fittings
Transfer supports shall not rotate within their fittings....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The proposed rule did not provide specific requirements for the cross section of transfer supports....
-
M305.2.8 Fittings
Transfer supports shall not rotate within their fittings when in place for transfer....
-
Horizontal Alignment
For horizontal alignment, the critical factor is the point at which users will instinctively decelerate to maintain a comfortable degree of lateral acceleration while traversing a curve....
-
M305.2.7 Clearance
Clearance between the transfer support gripping surface and adjacent surfaces or obstructions shall be 1 ½ inches (38 mm) minimum....
-
M305.2.4 Cross Section
Transfer supports shall have a cross section complying with 305.2.4.1 or 305.2.4.2....
-
United States of America v. State of Florida - Final Order of Dismissal
In this posture, the Court is confronted with a single, dispositive question of law: whether Title II confers standing on the Attorney General (and hence the Department) to sue.3 Consistent...
-
M305.2.5 Surface Hazards
Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges....
-
Service Animal Issues
Another important issue that a number of commenters raised concerned “emotional support animals.”...
-
How Can You Overcome These Barriers to Work with Your Providers?
There are many things that a person with a disability can do to improve his or her quality of health care and break down the barriers that compromise care. The following suggestions...
-
M305.2.1 Location
Transfer supports shall be located within reach of the transfer surface and shall not obstruct transfer onto or off of the surface when in position....
-
Changes in Level and Horizontal Gaps
car-borne or platform-mounted lifts, ramps or bridge plates, or manually deployed devices where it is not operationally or structurally feasible to meet the specified changes in level or horizontal...
- Guldmann GH3 Ceiling Lift - Horizontal Lifting
-
Conclusion
During this second phase of the independent wheelchair transfer study, platform transfers with and without grab-bars and a backrest and two-step transfers were evaluated. The study...
- Service and Companion Animal Owners: Know Your Rights!
-
Implication for Standards and Design
Each phase involved a highly customized transfer station iteratively developed with scientific, expert and consumer input to support the goals of the project. ...