Characters shall be selected from fonts where the width of the uppercase letter "O" is 55 percent minimum and 110 percent maximum of the height of the uppercase letter "I"....
Search Results "Transfer Surface Height"
-
703.2.4 Character Proportions
-
Positioning
According to ADAAG, positioning is dependent on two factors, height and location of grab bars, both of which were altered by designers to better accommodate an older population....
-
Obstructed High Reach
Obstructions at side reaches are limited to a height of 34”....
-
Limitations
Limitations The study is limited in scope by the following: Ability to generalize findings to trails in other locations with the same surfaces applied....
- Zurn Industries Trap Protector
-
409 Private Residence Elevators
In the final rule, call buttons are subject to requirements in section 309 for operable parts, including clear floor space (309.2), height (309.3), and operation (309.4) according to section...
-
LULA Elevators in Residential Dwelling Units
In the final rule, call buttons are subject to requirements in section 309 for operable parts, including clear floor space (309.2), height (309.3), and operation (309.4) according to section...
-
811 Storage
Provisions of this section address clear floor or ground space (811.2), the height of storage elements (811.3), and operable parts, such as storage hardware (811.4)....
-
§ 38.159(d)(4) Orientation
The padded barrier shall extend from a height of 38 inches (965 mm) from the vehicle floor to a height of 56 inches (1420 mm) from the vehicle floor with a width of 18 inches (455 mm), laterally...
-
11B-411.2.1.2.3 Accessibility function button
The International Symbol of Accessibility shall comply with Section 11B-703.7.2.1, and shall be 5/8 inch (15.9 mm) minimum in height. The indication shall be three raised dots....
- Whitehall Mfg. WH2142W2 Ligature-Resistant Toilet Wall Supply On-Floor Wall Waste
-
F105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
1117B.5.7
California's standards for signage are more stringent than Section 4.30 of the ADA Standards for Accessible Design. 1117B.5.7 Mounting location and height. ...
-
R305.2.1 Perpendicular Curb Ramps
On perpendicular curb ramps, detectable warning surfaces shall be placed as follows: 1....
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor....
-
11B-403.5 Clearances
Walking surfaces shall provide clearances complying with Section 11B-403.5....
-
11B-403.5 Clearances
Walking surfaces shall provide clearances complying with Section 11B-403.5....
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor....
-
§ 1194.25(j)(2)
(2) Where any operable control is 10 inches or less behind the reference plane, the height shall be 54 inches maximum and 15 inches minimum above the floor....
-
704.6 Structural stability
The wall shall extend to the height required by Section 704.11 and shall have sufficient structural stability such that it will remain in place for the duration of time indicated by the...
-
6. Grab Bars
Is there a horizontal grab bar at the head of the tub that is at least 12" long for stabilization and aid in transfer from a wheelchair to the fixed tub seat - see Figure 34 on page 25?...
- Zurn Z5550 ADA Elongated Water Closet