A ramp or transfer system to the top of the slide is not required. Where a sand box is provided, an accessible route must connect to the border of the sand box....
Search Results "Side Transfer Surface"
-
11B-240.2.1 Ground level play components
-
Summary of Major Provisions
The final rule adds new technical requirements for floor surfaces, bedrooms, and weather alert systems in emergency transportable housing units with mobility features....
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
7b.
[ADA Stds 4.13.9] Yes _____ No _____ A clear floor space on the latch side of the door (pull side) allows a person using a wheelchair or scooter to pull the door open and then...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
10.3.1(5)
Signs shall be placed at frequent intervals and shall be clearly visible from within the vehicle on both sides when not obstructed by another train....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
Dome Spacing: ADA Standard Section 705.1.2
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
11B-307.3.1 Edges and corners
Where signs or other objects are mounted on posts or pylons, and their bottom edges are less than 80 inches (2032 mm) above the floor or ground surface, the edges of such signs and objects...
-
11B-307.3.1 Edges and corners
Where signs or other objects are mounted on posts or pylons, and their bottom edges are less than 80 inches (2032 mm) above the floor or ground surface, the edges of such signs and objects...
-
AJW Architectural Products U122 128 oz. Dual Valve Liquid Soap Dispenser w/ Shelf - Surface Mounted
Product Features Fabricated of #20 gauge stainless steel with #4 satin finish Holds 128 fl oz. of liquid soap or hand sanitizer Secured with pin tumbler lock, keyed like all...
-
AJW Architectural Products U120 128 oz. Single Valve Liquid Soap Dispenser w/ Shelf - Surface Mounted
Product Features Fabricated of #20 gauge stainless steel with #4 satin finish Holds 128 fl oz. of liquid soap or hand sanitizer Secured with pin tumbler lock, keyed like all...
-
AJW Architectural Products UJ11 Series UJ11A Coat Hook Strip 24"L, 3 Hooks - Surface Mounted
Product Features Fabricated of #18 gauge stainless steel with #4 satin finish Units with greater widths require additional hooks Custom lengths available Product...
-
AJW Architectural Products U1525EA Series Automatic 120 Volt Hand Dryer, White Powder Coat - Surface Mounted
Product Features Fabricated of a heavy die cast aluminum with baked white enamel finish Hands free electric sensor provides easy operation Features a powerful 3450 RPM...
-
11B-404.2.9 Door and gate opening force
Powered doors shall be controlled on both the interior and exterior sides of the doors by sensing devices, push plates, vertical actuation bars or other similar operating devices complying...
-
11B-404.2.9 Door and gate opening force
Powered doors shall be controlled on both the interior and exterior sides of the doors by sensing devices, push plates, vertical actuation bars or other similar operating devices complying...
-
11B-404.2.9 Door and gate opening force
Powered doors shall be controlled on both the interior and exterior sides of the doors by sensing devices, push plates, vertical actuation bars or other similar operating devices complying...
-
11B-505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
-
11B-705.1.1.4 Resiliency
Detectable warning surfaces shall differ from adjoining surfaces in resiliency or sound-on-cane contact....
