Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
Search Results "Floor Designation"
Filters
Commonly Searched Documents
-
11B-306.3.4 Clearance reduction
-
11B-407.2.1.1 Height
[2010 ADAS] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline of...
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
11B-604.7.2 Disposal units
The disposal unit shall be located below the grab bar with the opening of the disposal unit 19 inches minimum (483 mm) above the finish floor....
-
11B-407.2.1.1 Height
[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
A. DEFINITIONS AND BACKGROUND
Part 36, including the ADA Standards for Accessible Design, 28 C.F.R. Part 36, Appendix A (the "Standards"). 2....
-
Panda TS.83 Thermally Broken Multi-Slide Door System
With multiple features in design, including specially designed gaskets and iso-bar technology this system can achieve a U-value of 0.29....
-
G.3.ii. - Are some types of secure electronic equipment, such as secure telecommunications devices that are specifically designed to prevent eavesdropping and other forms electronic attack, subject to Section 508 requirements?
Unless an exception applies, these technologies are considered EIT and must meet the Access Board standards. If "Tempest-tested" telecommunications systems are being used in an...
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
A. The Guidelines do not prescribe the type of product for grab bars, or the structural strength for grab bars. The Guidelines only state that the necessary reinforcement must be...
-
1115B.3.2, Item 3
.|_ On the other side of the water closet, provide a minimum of 28 inches (711 mm) wide clear floor space if the water closet is adjacent to a fixture or a minimum of 32 inches (813 mm)...
-
Addendum A: List of Terms
Transfer: a transfer that can be completed without the assistance or intervention Level Transfer- A transfer where the transfer surface is at the same height as the wheelchair seat to floor...
-
ADMINISTRATIVE AUTHORITY
[DSA-AC] A governmental agency that adopts or enforces regulations and guidelines for the design, construction, or alteration of buildings and facilities....
-
§382.151(a)
(a) As a carrier providing service using aircraft with 19 or more passenger seats, you must designate one or more CROs....
-
M101.4 Equivalent Facilitation
The use of alternative designs or technologies that result in substantially equivalent or greater accessibility and usability than specified in the MDE Standards is permitted....
-
4(2)(b)
(b) Design features such as sunken or raised functional areas do not interrupt the accessible route through the remainder of the dwelling unit....
-
§ 35.152(b)(2)(ii)
(ii) Should not place inmates or detainees with disabilities in designated medical areas unless they are actually receiving medical care or treatment;...
-
4.24.7 Faucets
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
9.4 Other Sleeping Rooms and Suites
Doors and doorways designed to allow passage into and within all sleeping units or other covered units shall comply with 4.13.5....
-
4.34.3 ADAPTABILITY
Accessible dwelling units may be designed for either permanent accessibility or adaptability....
-
Depth
The design allowed one to reach inside through the columns to some degree....
-
4.24.7 FAUCETS
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
Vehicle Parking Lot
An area specifically intended for parking of more than two motor vehicles, usually divided into multiple designated parking spaces. ...
