Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
Search Results "Designated Aisle Seat (Assembly)"
-
11B-903.6 Structural strength
-
Amusement Attraction
Examples include, but are not limited to, fun houses, barrels, and other attractions without seats....
-
106.5.6 Amusement Attraction
Amusement attractions include, but are not limited to, fun houses, barrels, and other attractions without seats....
-
607.4.2.3 Head End Wall
Figure 607.4.2 Grab Bars for Bathtubs with Removable In-Tub Seats...
-
4.1.7(2)(e)
(e) Displays and written information, documents, etc, should be located where they can be seen by a seated person....
-
4.34.5.5(4) Controls
In the shower stall in Fig. 35(a), all controls, faucets, and the shower unit shall be mounted on the side wall opposite the seat....
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Minimum Number: ADA Standard Section 234.4.2
Section 234.4.2 covers the most current ADA scoping requirements for the minimum number of wheelchairs spaces, transfer seats or devices at existing amusement rides.
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved....
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved....
-
Road Racing Wheelchairs
Typically, a low seating position is preferred to increase stability and decrease resistance....
-
11B-1005.3 Edge protection
Extending the deck of the fishing pier or platform 12 inches (305 mm) where the 34 inch (865 mm) high railing is provided is an alternative design, permitting individuals using wheelchairs...
-
11B-1005.3 Edge protection
Extending the deck of the fishing pier or platform 12 inches (305 mm) where the 34 inch (865 mm) high railing is provided is an alternative design, permitting individuals using wheelchairs...
-
1. Thigh Breadth
Thigh Breadth Thigh breadth was used to provide an estimate of the width of the seating surface....
-
Section 1193.2 Scoping (Section-by-Section Analysis)
Several manufacturers drew analogies to portions of facilities covered by the Americans with Disabilities Act (ADA), such as stadium seats, hotel rooms, and telephones in a bank as giving...
-
Interior Routes
Accessible route to all functional areas of restaurants and dining facilities. 11B-206.2.5 Accessible route to performance area from an assembly...
-
Interior Routes
Accessible route to all functional areas of restaurants and dining facilities. 11B-206.2.5 Accessible route to performance area from an assembly...
-
Purpose of the project
construction industry stakeholders to fill in the gaps in existing tolerances and procedures and to set specific tolerances and procedures for measurement for particular materials and assemblies...
-
1i
Are all of the small showers free of curbs or lips greater than 1/2" high at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
You must allow a passenger with a disability to stow assistive device inside the cabin
You must allow a passenger with a disability to stow his or her cane or other assistive device inside the cabin of the aircraft close to his or her seat if it fits, consistent with...
-
4.21.5 Controls
In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit shall be mounted on the side wall opposite the seat....
-
4.21.5 CONTROLS
In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit shall be mounted on the side wall opposite the seat....
-
§ 38.123(b)
(b) Restrooms required to be accessible shall be in close proximity to at least one seating location for persons using mobility aids complying with §38.125(d) of this part and shall be connected...
- GSA Section 508 Tutorials, Guidance, Checklists