The leading edge of the guardrail or barrier shall be located 685 mm (2.25 ft) maximum above the finish surface....
Search Results "Parking Surface"
-
R402.4 Reduced Vertical Clearance
-
R409.10.1 Top and Bottom Extension at Ramps
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent ramp run....
-
1018.6 Openings
This section requires openings in the surface of beach access routes and resting intervals such as spaces between boards to not allow passage of a sphere more than 1/2 inch in diameter....
-
6.11.1 Natural Elements
regulations or Forest Service construction and maintenance standards may define clear space and limit the allowable extension of natural protruding objects over the beach access route surface...
-
SECTION#4
SECTION#4 For the following questions, please answer every item pertaining to the sub-base installation, if the sub-base installation was necessary due to the installation of the trail surface...
-
ยง 38.25(b) Contrast
and the boarding edge of ramps or lift platforms shall have a band of color(s) running the full width of the step or edge which contrasts from the step tread and riser, or lift or ramp surface...
-
11B-307.3.1 Edges and corners
Where signs or other objects are mounted on posts or pylons, and their bottom edges are less than 80 inches (2032 mm) above the floor or ground surface, the edges of such signs and objects...
-
11B-307.3.1 Edges and corners
Where signs or other objects are mounted on posts or pylons, and their bottom edges are less than 80 inches (2032 mm) above the floor or ground surface, the edges of such signs and objects...
-
Bonded Bridle Path Installation
The same two binder systems used to fabricate the beach path surface (Soil-Sement and Vitri-Turf) were used for the bridle path trials....
-
Protruding Objects and Outdoor Recreation Access Routes
width area of an outdoor recreation access route, resting interval, or passing space and that are between 27 inches (685 millimeters) and 80 inches (2,030 millimeters) above the travel surface...
-
4.2 Stretchers
The second feature is the patient support surface (mattress), which is currently purchased separately from the stretcher deck....
-
After January 26, 1992
Examples of changes in usability include: changing a low pile carpet to a thick pile carpet, moving walls, installing new toilets, or adding more parking spaces to a parking lot....
-
Typical examples of reasonable accommodations are:
If the employer has an employee parking lot, reserving a parking space close to the entrance for an employee who has difficulty walking because of the loss of a leg, foot, or toe....
-
Requirements Regarding Mobility Devices and Aids
For some facilities -- such as a hospital, a shopping mall, a large home improvement store with wide aisles, a public park, or an outdoor amusement park -- covered entities will likely determine...
-
Summary of Major Provisions
(Forest Service); Department of Defense (Army Corps of Engineers); and Department of the Interior (Bureau of Land Management, Bureau of Reclamation, Fish and Wildlife Service, National Park...
-
Obstructed High Reach: ADA Standard Section 308.3.2
Section 308.3.2 covers the current ADA Standards for obstructed high side reach.
-
Water Play Components: ADA Standard Section 1008.2.3
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with 302, 403.3, 405.2, 405.3, and 1008.2.6...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Geometric symbols at entrances to toilet and bathing rooms shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Geometric symbols at entrances to toilet and bathing rooms shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
Boarding Pier Clearances: ADA Standard Section 1003.3.2
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....