If a walk crosses or adjoins a vehicular way, and the walking surfaces are not separated by curbs, railings, or other elements between the pedestrian areas and vehicular areas, the boundary...
Search Results "Kitchen Work Surface"
-
4.29.5 Detectable Warnings at Hazardous Vehicular Areas
-
3.4.7 Openings
Openings in the clear ground space and turning space surface shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter....
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor....
-
Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
Candidate, of the Center for Inclusive Design and Environmental Access at the State University of New York at Buffalo, who generously donated time and research expertise to the work of the...
-
American Standard Right Width 1.28-1.6 gpf FloWise Right Height Elongated Flushometer Toilet
support a minimum of 2,000 lbs (908kg) Extra Large Footprint Ideal for Remodeling Elongated, Open Front, Right Width toilet seat (Less Lid) Included Large water surface...
-
1. Significant risk of substantial harm
For example: An employer cannot assume that a person with cerebral palsy who has restricted manual dexterity cannot work in a laboratory because s/he will pose a risk of breaking vessels...
-
F236.1 General
Where operators provide a biceps curl machine and cable-cross-over machine, both machines are required to meet the provisions in this section, even though an individual may be able to work...
-
Proposed training standards.
The Department has always required that service animals be individually trained to do work or perform tasks for the benefit of an individual with a disability, but has never imposed any...
-
7. Assurances of compliance
While it is not feasible to adopt a single civil rights assurance form at this time, the Office for Civil Rights will work toward that goal....
-
Department or DOT or U.S. Department of Transportation:
The Federal agency that works to ensure a fast, safe, efficient, accessible, and convenient transportation system that meets the Nation’s vital national interests and enhances the quality...
-
Adaptability
It is not intended to include moving walls, relocating plumbing, replacing fixtures, widening door frames, or other work more appropriately addressed in design and construction....
-
D. Assisted Listening Devices:
Olympia shall ensure that the Assisted Listening Devices remain in good working order and any defects or issues are resolved expeditiously. ...
-
On-Site Readers
This is a stop-gap measure which may work when the meeting is short and there is not a large volume of material to be read....
-
11B-904.4 Sales and service counters
Exception: In alterations, when the provision of a counter complying with Section 11B-904.4 would result in a reduction of the number of existing counters at work stations or a reduction...
-
11B-904.4 Sales and service counters
Exception: In alterations, when the provision of a counter complying with Section 11B-904.4 would result in a reduction of the number of existing counters at work stations or a reduction...
-
11B-1009.5.7 Grab bars
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (102 mm) minimum and 6 inches (152 mm) maximum above each step and transfer platform....
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Backrests
Backrests: The backrest design for platform 1, the first surface that participants transferred to from their WMD as seen in Table 2, was based on bench seat back supports in section 903.5...
-
1017.5 Tread Obstacles
The vertical alignment of joints in concrete, asphalt, or board surfaces on trails can be tread obstacles....
-
Instrumentation for Analysis
Upon installation, the playground owner completed a questionnaire (Appendix B) on the type, size and intended age group of the playground, the total cost for the equipment, surface materials...
-
Additional Technical Criteria Considered for Handrails on Ramps
These technical criteria are available at http://www.access-board.gov/ada-aba/final.cfm#a505 and address continuity, height, clearance, gripping surface, cross section, surfaces, fittings...
-
11B-505.10.3 Bottom extension at stairs
Extension shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
1009.5.7 Grab Bars
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above each step and transfer platform....
