provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
Search Results "End Transfer Surface"
-
M301.4.1 Clearance in Base
-
11B-801.1 Scope
For example, Section 11B-806 addresses guest rooms in transient lodging facilities while Section 11B-902 contains the technical specifications for dining surfaces....
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
R302.7 Surfaces....
-
III-4.4600 Seating in assembly areas
And in order to facilitate seating of wheelchair users who wish to transfer to existing seating when fixed seating is provided, a public accommodation must provide, to the extent readily...
-
A. Background
Because of his disability, and the height of the DEXA equipment used by Jefferson Outpatient, the complainant needed assistance to transfer from his wheelchair to the DEXA machine. ...
-
Sec.36.403(c)(1)(ii)
(ii) Replacing an inaccessible floor surface in the customer service or employee work areas of a bank;...
-
Walk
An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts....
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate FS 33538 of Federal Standard 595C....
-
§ 36.403(c)(1)(ii)
(ii) Replacing an inaccessible floor surface in the customer service or employee work areas of a bank;...
-
RAMP
A walking surface in an accessible space that has a running slope greater than 1:20....
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate 33538 of SAE AMS-STD-595A....
-
5.7.1 Lift Compatibility Clearance in Base for M301
effective, they must deploy at diagnostic equipment such that the boom of the lifts can maneuver far enough over the equipment to safely lower and raise the patient onto and off examination surfaces...
-
¾ Inch Minus and ¼ Inch Minus Limestone
The surface stayed soft under foot, enough to see footprints compacted and not return to the surface, but did not show any signs of erosion....
-
Soiltac Liquid Topical
The first noticeable signs of change for this surface came after the first heavy rainfall at the March 2008 testing....
-
Orientation (slide 12)
You know, any time you go through [circulation areas], not when you get to the end. But as you go down the line, the waiting areas are separate....
-
16. Meetings with Class Counsel
Within six (6) months after the end of the Compliance Period, but no less than three months prior to the termination of the District Court’s jurisdiction herein, the City shall provide Class...
-
408.4.1 Car Dimensions and Doors
Car doors shall be positioned at the narrow ends of cars and shall provide 32 inches (815 mm) minimum clear width. EXCEPTIONS: 1....
-
Golf Club Reach Range Area: ADA Standard Section 1007.3.2
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole....
-
Height: ADA Standard Section 606.3
Section 606.3 covers the current ADA Standards for the height of lavatories and sinks.
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ◼ ...
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...