The Get Smart Collection consists of styles including: 24 x 24 carpet tile, 12"x36" carpet tile and broadloom, with coordinating hard surface....
Search Results "Dining Surface"
Commonly Searched Documents
- Mohawk Group Chilled Check Carpet Tiles
-
12. Annual Commitment for Program Access Improvements
so that the sidewalk or walkway surfaces are made accessible to and usable by persons with Mobility Disabilities; (c) Upgrading of existing curb ramps to comply with the standards set...
- Face® Dipstick® Profiler Precise, Accurate & Repeatable (Concrete/Pavement Flatness & Levelness)
-
When is a Curb Ramp a Ramp?
[DSA-AC] A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face. 1991 &...
- Yale 1500 Series Traditional Exit Devices
- Besam SW100 Low Energy Swing Door Operator
- Landscape Forms Inc. Plexus Bench Collection
- ASI Global Partitions Phenolic Black Core Partition
- Kawneer North America 1040 Sliding Mall Front Door
- ASI Global Partitions Plastic Laminate Partitions
- Kohler® Mazz Single-Handle Pull-Down Sprayer Kitchen Faucet in Vibrant Stainless
- Compliance Signs Van Accessible Parking Sign (Green Text on White)
- Ramp NOW Alumiramp Modular Ramps
-
Q1.) When a ramp has a maximum slope of 1:12 or 8.33%, is that considered a range of from 0% to 8.33% which would allow no slope greater than 8.33% or is that a simple maximum which would allow a tolerance above 8.33%? Similarly, is a cabinet countertop that can be no higher than 34” AFF a range of from 0” to 34” AFF with no additional height allowed, or is a tolerance allowed for variations in the floor surface or cabinet construction?
A1.) The consistent technical assistance on this question has been that both are subject to tolerances.
-
806 Transient Lodging Guest Rooms
The Board has removed the minimum surface requirement (2 square feet) for vanity counter tops....
-
F203 General Exceptions
Also, ADA scoping provisions for work surfaces are clarified in the final rule as not applying to those provided for use by employees (226.1)....
-
2. Background
., curb ramps and blended transitions, and detectable warning surfaces)....
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
These commenters argued that requiring the equipment to be designed to accommodate transfer in both positions would not achieve any objective benefit and would impose transfer surface width...
-
Bed Height Fact Sheet
All beds (including the railings, box spring, and mattress) within a mobility accessible (ADA) room should be no higher than 23” and no lower than 17” above the floor surface....
-
Getting From Here to There—Outdoor Recreation Access Routes
Design outdoor recreation access routes to meet technical requirements for running and cross slopes, resting intervals, surface, clear tread width, passing spaces, tread obstacles, protruding...
-
III-6.1000 General
The new floor must comply with, for example, ADAAG requirements for a nonslip surface or with the ADAAG carpeting requirements, if applicable....
-
Paragraph (e) (Advisory Guidance)
Controls which have non-slip surfaces and those that can be operated with the side of the hand, elbow or pencil can be used to minimize physical activity required....