The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
Search Results "Ligature Resistant"
Filters
Commonly Searched Documents
-
11B-504.4.1 Contrasting stripe
-
4. Organization of Technical Criteria
For example, X-ray equipment that is designed for use in a standing position for certain procedures would have to meet the technical criteria for slip resistant standing surface and standing...
-
Arriving at the Polling Place: Parking
Accessible parking spaces and the access aisles serving them must be on a surface that is stable, firm, and slip resistant (e.g., clear of gravel or mud) without wide cracks or broken pavement...
-
Section A: Parking
.) (§502.4) A5 Are the surfaces of the designated accessible parking spaces and access aisles stable, firm, and slip resistant?...
-
Areas of Sport Activities
Areas of sport activities must comply with all ADAAG requirements, except that they are exempt from the requirement that surfaces must be stable, firm, and slip resistant, and from the restrictions...
-
Introduction
This surfacing material concept was to mix a binder with EWF to create a stiff (firm) and scuff-resistant (stable) composite....
-
Surfaces for Outdoor Recreation Access Routes
Slip resistance is not required because leaves and needles, dirt, ice, snow, and other surface debris and weather conditions are components of the natural environment and would be difficult...
-
Exterior Routes
EXTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Openings in floor or ground...
-
Exterior Routes
EXTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Openings in floor or ground...
-
NFPA
conductors are contained in a 2-hour rated cable assembly, or enclosed (installed) in a 2-hour rated enclosure or a listed circuit integrity (C.I.) cable, which meets or exceeds a 2-hour fire resistive...
-
Areas of Rescue Assistance [4.1.3(9), 4.3.11]
Because exit stairs are often required to be fire resistant by fire or life safety codes, areas of rescue assistance are often located at landings....
-
Section 37.75 Remanufacture of Non-Rail Vehicles and Purchase or Lease of Remanufactured Non-rail Vehicles by Public Entities Operating Fixed Route Systems
All modifications that can be made without altering the historic character (such as slip resistant flooring) must be done....
-
Key Differences Between Routes
drainage —1:20 (5%) Technical Requirements for Width and Surface Minimum Width Surface AR 36 inches Firm, Stable, Slip Resistant...
-
Surface [1017.2]
A firm trail surface resists deformation by indentations....
-
Selecting a TTY
Vandal-resistant and weather proof TTYs are available for outdoor use, including at exterior-only sites such as highway rest areas and parks....
-
Manual Wheelchairs
Braking is accomplished by resisting wheel movement with the hands or arms....
-
Electric Bicycles
Bicycles Electric bicycles are similar in geometry to human-powered bikes but have a motor that provides pedal assistance and allows riders to accelerate, climb hills, and overcome wind resistance...
-
RECOMMENDED CHANGE
RECOMMENDED CHANGE Revise the Section 5.4.11 recommendation as follows: The Committee recommends transfer supports and connections contain the strength to resist vertical forces of...
-
1. Transfer Supports
The proposed standards required transfer supports to be located within reach of the transfer surface and not obstruct transfer, be capable of resisting vertical and horizontal forces of...
-
M304 Diagnostic Equipment Used by Patients in Standing Position
M304.2 and M304.3 would require a slip resistant standing surface and standing supports to accommodate patients with mobility disabilities who ambulate, patients who have limited stamina...
-
DSA IR 16-12: GRAB BAR DESIGN AND CONNECTIONS: 2019 CBC
DESIGN REQUIREMENT: Grab bars shall be designed to resist a single concentrated load of 250 LBS applied in any direction at any point on the grab bar such as to produce the maximum load...
-
704.8 Allowable area of openings
Buildings whose exterior bearing wall, exterior nonbearing wall and exterior structural frame are not required to be fire-resistance rated shall be permitted to have unlimited unprotected...
-
11B-504.4.1 Contrasting stripe
The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
-
903 Benches
Specifications for benches address clear floor or ground space (903.2), size (903.3), back support (903.4), height (903.5), structural strength (903.6), and slip resistance in wet locations...